Anton Paar PA 5 User manual

Product Information
PA 5 – Battery Exchange
www.anton-paar.com | Created by Kreisel, Gudrun 22.03.18 | H17IE006EN-A_ProdInfo_OBA1_BatteryExchange.docx page 1 of 2
1 Battery Exchange of PA 5
You purchased an exchange battery (mat. no. 106781) for your PA 5. To carry out the battery exchange, please
follow the instructions given in this product information.
1.1 Battery Exchange
1. Before exchanging the battery, switch off the PA 5.
NOTICE
When removing the cover, never turn the cover completely because the cables inside the manometer may unplug
or twist.
2. Open the PA 5 by carefully moving the cover back and forth.
3. In the opened PA 5 manometer is a small plug as shown in Figure 1. The plug connects the battery to the
PA 5.
Figure 1: Plug for the battery
4. To remove the battery, disconnect the battery first.
To disconnect the battery open the plug soldered to the battery. Use the screwdriver supplied with the PA 5
as shown in Figure 2.
Figure 2: Screwdriver to open the plug soldered to the battery
5. To open the plug push the tip of the screwdriver into the central flange and push the two parts of the plug
apart as shown in Figure 3.
Plug

Product Information
PA 5 – Battery Exchange
www.anton-paar.com | Created by Kreisel, Gudrun 22.03.18 | H17IE006EN-A_ProdInfo_OBA1_BatteryExchange.docx page 2 of 2
Figure 3: Push the plug apart with the screwdriver
6. After you opened the plug you can remove the flat battery and insert a new battery (mat. no. 106781).
7. Close the plug of the new battery.
8. Close the cover of the PA 5 manometer carefully.
1.2 Synchronizing PA 5 with a Computer
NOTICE
After exchanging the battery, you have to synchronize the manometer time with the computer time.
When no synchronization was carried out, subsequent tests cannot be read out from the PA 5
, because the
manometer time and date cannot be processed by the PetroNet software.
1. To synchronize the PA 5 time with your computer time open your PetroNet software.
2. Connect the PA 5 to the PetroNet software as described in the instruction manual.
3. Click on the button <Synchronize PA 5 time with PC> as shown in Figure 4.
The PetroNet software synchronizes know the PA 5 and your computer.
Figure 4: Synchronizing the PA 5 with your computer
Contact us at
Anton Paar ProveTec GmbH
E-Mail: [e-mail]
Website: www.anton-paar.com