antoniolupi STECCA600 User manual

STECCA
USAGE AND INSTALLATION MANUAL
WARNING!!!
We decline any and all responsibilities relative to
eventual inaccuracies contained in this manual due to
transcription errors.
We invite all our clientele to control the items received
prior to installation.

Pag 2
so󰀩tto
pavimento
FIG.1 - FIG.2
g= minimum height from the ground is 60 cm
v = lowest height from oor 60 cm
m= minimum distance from side walls and from the ceiling is 10 cm
*to power supply
Ceiling
Floor

Pag 3
Tab. 1
TAB.1
Model Version h x w
(cm)
a
centre to
centre
distance
c
(cm) Weight (kg)
electric
power
(watt)
STECCA600 12x60 7 56,7 2,9 65
STECCA900 12x90 7 86,7 3,7 105
STECCA1200 12x120 7 116,7 4,5 150

Pag 4
Fig. 3
so󰀩tto
pavimento
FIG.3
Ceiling
Floor

Pag 5
Fig. 4
FIG.4

Pag 6
Fig. 7
L N
fase (marrone) neutro (blu)
live (brown) neutral (blue)
phase (braun) neutral (blau)
phase (marron) neutre (bleu)
fase (marrón) neutro (azul)
L
N
FIG.6- FIG.7

Pag 7
The present radiator has been produced by:
Radiatori 2000 S.p.A. – Via Francesca 54/A 24040 Ciserano
(BG) ITALY
P.IVA 03554100176
IMPORTANT!!
Antonio Lupi Design S.p.A. declines any and all responsibilities
in case of accidents due to installations that do not comply to
these instructions.
Before leaving the factory, all radiators are rigorously tested
according to current standards. Antonio Lupi Design S.p.A.
reserves the right to introduce technical and constructive
modications retained necessary without obligation of prior
notice.
For any and all questions please consult your nearest dealer.
1. INFORMATION ABOUT THE PRODUCER
Index
1Information about the producer pag 7
2Warnings and precautions pag 8
3Instructions for assembly pag 11
4Tools required for installation pag 11
5Material found in the package pag 12
6Pre-mounted radiator in the package pag 12
7Predisposition for wall supports pag 13
8How to mount the radiator on the wall pag 13
9Chronothermostat manual pag 14
10 Notes for disposing of the product pag 15
11 Conformity declaration. pag 15

Pag 8
Please read carefully all warnings and precautions listed
below.
The instructions contained in the present manual can be
downloaded from our website www.antoniolupi.it
2. WARNING AND PRECAUTIONS
• The appliance operates at 230V AC. Make sure the line
voltage corresponds.
• Theappliance belongs toclass II andiselectrically protected
IPX4; do not make electrical connections while ignoring this
information
• Make sure you have the necessary power shown on the
data plate for the good functioning of the appliance.
• This appliance is intended for drying only water washed
fabrics.
• The appliance must not be placed immediately below a xed
socket.
• If the power cord is damaged, it must be replaced by the
manufacturer or its service department or however by a
qualied person, so to prevent any risk.
• In the event of a defect, contact the retailer. Don’t tamper
in any way with the product; any disassembly or opening
compromise the safety of the product. Liability is declined
for accidents arising from any kind of tampering done on the
electrical appliance.
• Do not touch the appliance during operation.
• The protection system of this heating equipment was
designed to avoid direct access to the electrical heating
elements and must be maintained in its position during use.

Pag 9
• The appliance can be used by children less than 8 years old
and by people with reduced physical capacity, sensory or
mental, or lacking in experience or the necessary
• knowledge, as long as under surveillance or after having
received instructions regarding the safe use of the device
and understanding of the dangers inherit to it.
• Children must not play with the appliance.
• Cleaning and maintenance to be carried out by the user and
must not be carried out by children without surveillance.
• Children under 3 must be kept away from the appliance if
not continuously monitored.
• Children between the ages of 3 and 8 years old must only
turn on / o󰀨 the appliance under conditions that this has
been placed in the normal operating position expected if
supervisedandiftheyreceivedinstructionsconcerningsafety
and potential dangers related to the use of the appliance.
• Children aged between 3 and 8 years old must not connect,
adjust or clean the appliance or perform maintenance on the
device itself.
• The electric radiator must be mounted and installed away
from possible contact with water and electrical command
devices and operation must not be placed within reach of
people that being in bathtubs,showers or similar situations
could touch them.
• Before carrying out any type of cleaning make sure that
the electric radiator is o󰀨, at room temperature and that the
circuit is disconnected.
• Clean with damp cloths without using aggressive detergents
or abrasives that could compromise the painting of the unit.
2. WARNING AND PRECAUTIONS

Pag 10
• Do not load or hang excessive weights, the ow rate of these
structures is calculated to support max. 2 Kg.
• The minimum height from the ground of these elements
must not be less than 60 cm.
CAUTION!!
Some parts of the radiator may become very hot
causing burns. Pay attention to children and persons
whose physical, sensorial and/or mental conditions
are reduced.
2. WARNING AND PRECAUTIONS

Pag 11
3. INSTRUCTIONS FOR ASSEMBLY
• Connect to the line only after xing mechanically the radiator
to the wall.
• Connections must be made only by qualied and experienced
personnel and must be performed in compliance of current
regulations using certied material.
• Donot attemptto tamperwith thebody ofthe radiatornor the
electric box.. If you have problems, contact the retailer. The
cable supplied (g.5 letter “T”) is designed specically for
the application. Don’t try to replace it with other unsuitable
cables.
• In the power supply network to the appliance, according
to the rules of installation, you must foresee a device that
ensures the omni polar disconnection of the network, with
an opening distance of contact that allows the complete
disconnection of the category of overvoltage III.
• In the event that the load of the radiator is higher than that of
the data plate of the command or control system (contact of
thermostat or control switch) interpose a relay of power or a
suitably sized contactor.
• It is mandatory that the power supply circuit device is
protected by a di󰀨erential high sensitivity protection device.
WARNING!!
Read all instructions and measurements carefully
for the correct assembly of the radiator listed in the
present document in Tab.1, Fig.1, Fig.2 and Fig.3.
• Screwdriver (in the case of using the supplied dowels);
• Drill;
• Wall tip D. 8 mm (in case of use of the dowels provided).
• 3 mm Allen wrench
4. TOOLS REQUIRED FOR INSTALLATION

Pag 12
6. PRE-MOUNTED RADIATOR IN THE PACKAGE
Before being packed, the radiator is supplied with some
components in order to facilitate and speed up the phases of
installation. In particular, the radiator is already installed with
(Fig.2):
• 1 dry electrical heating element
• An electronic timed control system
• 1 10-foot-long electrical connection cable “T”
5. MATERIAL PROVIDED IN THE PACKAGE
• 2 Complete anchors Ø8 - Cod. I
• 2 Wall brackets - Code L
• 2 Allen screws M5 - Code N

Pag 13
• Insert the cable “T” in the electric pipe “U”; the distance must
be less than 3 meters.
• Lift the radiator and insert the two crosspieces mounted on
the radiator, in the “L” brackets (Fig. 4);
• Pulling the end of the cable inside the junction box, reduces
excess cable behind the radiator.
8. WALL MOUNTED RADIATOR ASSEMBLY
• Withdraw from the accessory package the two “L” wall
brackets, the plugs “I” and the screws “P” and “N”;
• Prepare holes in the wall “O” for the plugs (Supplied “I” xing
bolts D.8 mm suitable for reinforced concrete walls);
• Fix the brackets “L” using the screws “P” to the wall
• Insert the towel warmer in the brackets previously xed to
the wall
• Fix the heated towel rail to the wall using the screws “N”
7. DISPOSITION OF WALL SUPPORTS

Pag 14
7. CHRONOTHERMOSTAT MANUAL
Stand-By Mode:
In stand-by mode the device is switched o󰀨 and projects a light
blue ligh
Manual start:
the device is switched on by touching, for 5 seconds, the
“TOUCH” switch on the side of the appliance. The status of on
is shown by the turning on of a green light on the
inside of the appliance. The appliance stays turned on until it is
not switched o󰀨 manually by touching the control “TOUCH” for
2 sec
Timed power on:
The device is switched on by touching for 1 second the
“TOUCH” control on the side of the appliance. The status of on
is indicated by the red light coming on inside the appliance. The
appliance remains on for a preset time of about 1 hour after
which it will turn o󰀨
automatically.

Pag 15
9. NOTES FOR DISPOSING OF THE PRODUCT
The presence of a crossed-out mobile container on the product
indicates that within the European Union all electrical products
and electronic devices are subject to special collection at the end
of their life cycle. Do not dispose of these products in unsorted
municipal waste. Dispose of the product accordingly to avoid
any damage to the environment or human health caused by
incorrectdisposalandtopromotesustainablereuseofrenewable
resources.
Furtherinformationonthecollectionmethodsareavailablebythe
retailer, the local competent authorities or national organizations.
For more information, see specic country information.
Conformity declaration
WeherebydeclarethatthisradiatoroftheBITCollection
was built in compliance with European Directives
2006/95 LVD, EC 89/336 RHOS, RAEE and the
Regulations
CEI EN 60335-1, CEI EN 60335-2-30,
CEI EN 60335-2-43, 2004/108 EC.
Data ………………………
10. CONFORMITY DECLARATION
