Anzzi BYNE Series User manual

INSTALL GUIDE
Model#
SH-AZ013
BYNE SERIES
PERFECTION IS OUR TRADITION™
v2.0516

Parts List Pg. 1
Before You Start Pg. 2
Spec Drawing Pg. 3
Installation Pg. 4
Care & Maintenance Pg. 13
Warranty Pg. 14
Registration Final Page
TABLE OF CONTENTS
YOUR REVIEWS MATTER!
For more information please call 1-844-44-ANZZI
or email us at [email protected]
The ANZZI™ Family thanks you for your purchase and hopes you enjoy your very own ANZZI
product for years to come! In the meantime let us know about your experience? We would love
to hear your thoughts from the packaging to the quality and function of the product.
Leave a review on www.ANZZI.com/reviews and let everyone know how satisfied you are with
ANZZI!
Also, we humbly request submitting as many pictures as possible along with your review.
Millions of shoppers will want to know about your experience with our products. Don’t just tell
but show, too!

PARTS LIST
PERFECTION IS OUR TRADITION™
pg. 1
ASME A112.18.1/CSA B125.1

PERFECTION IS OUR TRADITION™
pg. 2
For any questions or concerns contact
our dedicated technical support team
at 1-844-44-ANZZI.
BEFORE YOU START
Screwdriver Channel Locks
Adjustable Wrench Allen key
Goggles
Teflon tape
Recommended Items
ATTENTION: Please read all instructions thoroughly
including all warnings, attentions and notes before
beginning installation.

PERFECTION IS OUR TRADITION™
pg. 3
SPEC
DRAWING
mm
[inches]

Figure 1
INSTALLATION
PERFECTION IS OUR TRADITION™
pg. 4
Drill holes according to the drawing shown.Step 1A

Figure 2
INSTALLATION
PERFECTION IS OUR TRADITION™
pg. 5
Connect plumbing supply lines to the facuet valve as shown.
Make sure the hot and cold supply lines are connected to the pertaining sides.
Step 2A
Step 2B

Figure 3
INSTALLATION
PERFECTION IS OUR TRADITION™
pg. 6
Add Teflon tape and screw the diverter adapter to the pipe ran from above the faucet valve.Step 3A

Figure 4
INSTALLATION
PERFECTION IS OUR TRADITION™
pg. 7
The spout comes with a male thread adapter that can be used or removed depending on
existing connections.
Apply Teflon tape to the pipe connections and screw the spout onto the pipe.
Step 4A
Step 4B

Figure 5 Figure 6
INSTALLATION
PERFECTION IS OUR TRADITION™
pg. 8
Separate the rear anchor for the shower arm.
Place the anchor in the desired position.
Pre-drilled the holes to insert the wall anchors.
Secure the shower arm anchor with the (x2) screws supplied using a Philips screwdriver.
Install the shower arm to the anchor until it’s tighten in the upright position.
Then, secure it using the (x2) set screws provided.
Step 5A
Step 5B
Step 5C
Step 5C
Step 6A
Step 6B