Aosom 370-189V80 User manual

ASSEMBLY INSTRUCTION
IN220700013V01_US_CA
370-189V80
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
●Music
● Forward
! WARNING: This product must be assembled
by an adult. When unassembled, there are small
and sharp parts, which could be choked on if
swallowed. Keep out the reach of small children.
Warning: Do not use in traffic.
EN

L9
K1
J1
I1
E1 D3
C1
B1 A1
H1 G4
F1
M8 spanner
Motor Washer
Wheel cover
Basket Buffer beam
Seat
M1N4
Car body
M8 nut
Driving wheel Handlebar
Wheel
Cotter pin
Rear axle
P1 O4
Screw Charger

Product specification
Battery
Suitable age
Loading capacity
Product size
Speed
Charge/use time
Charger
6V
18-36 months
25kg
70*42*45cm
1.0-3.0km/h
Charge 8-12h, Use 45min
6V
③
④
⑤
②
①
Function
① Forward
② Music switch/Volume -
③ Pause/play
④ Music switch/Volume +
⑤ Music power switch

Assembly installation
2. Rear axle, wheel and motor assembly
1. Front wheel assembly
Add 1pc washer to the rear axle from the long side. Turn the car body over, then insert
rear axle into the car body like picture. Add 1pc motor,1pc driving wheel, 1pc washer
step by step to the left side of the rear axle, use 1pc cotter pin to tighten(bend the cotter
with plier), then insert 1pc wheel cover into the wheel. Add 1pc washer, 1pc wheel, 1pc
washer step by step to the right side of the rear axle, use 1pc cotter pin to tighten(bend
the cotter with plier), then insert 1pc wheel cover into the wheel.
Add 1pc washer, 1pc wheel, 1pc washer step by step, use 1pc cotter pin to tighten
(bend the cotter with plier). At last, insert 1pc wheel cover into the wheel. The same
assembly step for the other side.
→

3. Handlebar assembly
Insert the handlebar into the hole on the car, then insert the direction lever into the hole
on the front axle, add 1pc washer, use 1pc M8 nut to tighten. Pass the handlebar line
through the hole under the seat, then connect the handlebar line and the car line.
4. Basket and buffer beam assembly
Insert the basket into the holes on the car, use 4pcs screw to tighten. Insert the buffer
beam into the hole on the front bumper.

5. Connect the motor line and battery line
Connect two white connectors(motor line) like picture.
Connect two red connectors (battery line) like picture.
6. Seat assembly
Insert the seat into the car, then lock the seat.
WARNING
- For children's safety, please follow these instructions carefully.
- Adult assembly and adjustment are required, keep children away.
- Small parts are present when assembling, keep small children away to prevent
choking.
- Children must wear the safety belt when riding.
- Adult supervision is always required when riding. Teach children how to ride before
using.
- Never stand or play when the product is moving.
- Battery to be charged by adults only. Fully charge the product before first use.
- Keep children away from plastic packaging to prevent suffocation.
- Only use spare parts that are provided by the manufacturer.
- The charger is not a toy and shouldn't be played with.
- Maximum load: 25kg. Do not overload.
- Suitable age: 18-36 months.

Safety use
- Do not use in the street, on the road or near slopes and ditches.
- Do not change the wire or add electrical devices to the car.
- Use in a dry area, keeping away from wet conditions. Keep away from open flames.
- Suitable for 1 children. Do not overload.
- Maximum capacity is 25kg.
- When not in use, switch off the power. If not in use for a long period, unplug the
battery.
- Check battery, charger and other parts regularly. If damages are found, ensure they
are fixed before using.
- Before the first use, charge for 10 hours.
- Place the charger into the hole under the seat, then plug the charger into the socket.
- The car cannot be used when charging.
- Do not charge for more than 12 hours.
- When charging, it is normal for the battery and charger to be warm.
- Do not charge if the plug is wet to avoid electrical hazards or a short circuit.
- Only use the charger provided by the manufacturer. Any other charger can damage
the battery or cause a short circuit.
- If not in use for a long period, ensure it gets charged once a month.
Charging notification
Charging steps are as follows:
Step 1: The charging hole is under the seat.
Step 2: Put the charger plug into the hole.
Step 3: Connect the charger to a power socket.
Warning: Car must be charged by an adult. This product cannot be used when
charging.

Problem solution
Maintenance and Service
● Check battery, charger and other parts regularly. If there are any damages, ensure it
is fixed before using.
● Use lubricating oil for parts. Keep this product away from open flames and out of
direct sunlight.
● Store indoors and use a water-resistant cover.
● Keep away from flammable materials to avoid fire hazards.
● Charge the product after each use.
● Clean with a dry cloth. Do not use chemical solvents to wipe plastic parts. Do not
wash with water. Do not use when raining or snowing – water can damage the motor,
electric system or battery.
● Switch off the power after each use.
● Only use the charger provided by the manufacturer.
● Do not modify this car or its electric wire in any way.
Car can not move
Problem Analysis Solution
Battery low power
Fuse protect
Charge battery
Reuse a few minutes later
Power not turn on
Battery line loose
Battery damaged
Electric device damaged
Motor damaged
Turn on it again
Reconnect
Replace a new one
Replace a new one
Replace a new one
Battery connector loose
Charger not plug in
Charger damages
Battery can not
be recharged
Reconnect
Replug
Replace a new one
Car does not run
very long
Battery power low
Battery is old
Recharge
Replace a new one
Charger feels warm
when charging Chemical reaction Normal
Speed slow Battery is old
Battery power low
Overloaded
Road is not even
Replace a new one
Recharge
Reduce weight under 25KG
Play in a smooth area

● Musique
● Marche avant
FR
AVERTISSEMENT : Ce produit doit être
assemblé par un adulte. À l'état non assemblé, il
présente des pièces de petite taille et tranchantes,
qui risquent de provoquer un étouffement en cas
d'ingestion. Tenez-le hors de portée des jeunes
enfants.
Avertissement : À ne pas utiliser dans la circulation.
IMPORTANT : A LIRE ATTENTIVEMENT ET À CONSERVER POUR
CONSULTATION ULTÉRIEURE.
INSTRUCTIONS DE MONTAGE
IN220700013V01_US_CA
370-189V80

L9
K1
J1
I1
C1
B1 A1
H1 G4
F1
Clé M8
Moteur Rondelle
Enjoliveur de roue
Basket Poutre tampon
Siège
M1N4
Carrosserie
Écrou M8
Roue motrice Guidon
Roue
Goupille
Essieu arrière
P1 O4
Vis Chargeur
E1 D3