Apevia ATX-998KL User manual

ATX998KL Installation Guide
1:Unscrew the thumb screws 2.Pull the side panel back then 3:Find the motherboard stand-offs
from side panel. pull out. from the enclosed screw box.
4:Put the motherboard stand- 5.Sit the motherboard on the 6.Find screws in the screw box.
offs on the motherboard tray. motherboard tray.

7.Screw in all the screws into the 8.Same as step 7.
motherboard stand-offs
9.Take out front panel:(Optional. Only if you need to install case fans in the front)
Step (1): Unscrew the side Step (2): Take out the side Step (3): There are 6 screws hold
Panel (motherboard side) panel (motherboard side) the front panel to the case. Unscrew
3 screws at one side from inside of
the case.
Step (4): Unscrew the other Step (5): Pull out the front panel 10. Optional: Install case fan in
3 screws from the other side. from the bottom. the front panel (You can put up
to 2*80mm fans). Then screw the
front panel back.

11.Optional:Install case fan 12.Take out 5.25” metal plate 13.insert 5.25” drives (DVD,
at rear (1*80mm-120mm fan) & bay cover by pushing out CD-R, CD-RW)
frominside(youmayusea
screw driver to force it out)
14.Secure the 5.25” drives 15.Push out 3.5” metal plate 16.Slide in 3.5” drives and
in place with screws. & drive cover from inside (You secure in place with screws.
use a screw driver to force it out)
17.Install 3.5” hidden drives 19.Screw all 3.5” hidden 20.Find the 20-pin main power
such as hard drive, zip drive. drives in place. connector from power supply.

21.Plug into your motherboard. 22.Find the 4-pin P4 connector 23.Plug into motherboard.
Different M/B has different from power supply.(for P4 only) (for Intel P4 motherboard only)
Layout. Please refer to M/B
user manual.
24.Find 2*USB cables. 25.Plug USB cables to your M/B. 26.Find “HDD LED” and
(USB1 & USB2) Please refer to M/B user manual. “Reset SW” cables.
27.Plug them onto your M/B. 28.Find “Power SW” and “+P LED” 29.Find “Case Speaker” from
Please refer to M/B user manual. “-P LED” cables and plug onto M/B. screw box.
Please refer to M/B user manual.

30.Install Case Speaker to M/B 31.Connect case fans by linking 32.Find “Case Feet” in screw box. Lay
following M/B user manual. together all 4pin female and male case down and snap “Case Feet” on
connectors of all fans. There will
be 1*Female & 1*Male left out at
each end. Connect the 4-pin Male
to a 4-pin Female from power supply.