Apevia X-Qpack User manual

X-Qpack Series Installation Guide
View of X-Qpack from different angles
1.Unscrew U-Shape cover. 2.Take out the U-Shape cover. 3.Unscrew the motherboard
tray.
4.Pull out the motherboard tray. 5.If your motherboard size and layout 6.Install motherboard.
is not universal standard, then you need
to remove the I/O bracket and replace with
the one that comes with your motherboard.
7.Screw the motherboard on 11.Push motherboard tray back to 12.Remove 5.25” drive plate.
motherboard tray the case. It’s easier to use a screw
drivertopullitoutalittle.

10.Then bend it up and down to 11.Once you detach the plate, 12.Unscrew the HDD cage.
detach it. Use a screw driver to knock it out.
13.Pull up and take out the HDD 14.Install 5.25 drives. 15.Screw them in place.
cage.
16.Install 3.5” drives. 17.Screw them in place. 18.Put the HDD cage back.
19.Screw it up. 20.LCD sensors: You can tape 20.Tape another temperature
temperature sensor on HDD to sensor on the heat sink of CPU
get more accurate temperature fan to get CPU temperature.
of HDD. Then, connect the 4-pin male
connector from the LCD to
power supply 4-pin female
connector.

Note:
For front USB, Firewire and Audio ports installation, please refer to your motherboard user’s
manual.
22.Put the U-Shape cover back and 23.You can carry it with the
screw up. Front handle. It takes up to
40lbsofweight.
X-Qpack Series USB/1394/Audio cable pin assignment
Cable Cable Color Function
RED +5V
WHITE -D
GREEN +D
USB 2.0
BLACK GND
WHITE VP
BLACK VG
RED TPB-
GREEN TPB+
BROWN TPA-
1394
BLUE TPA+
RED MIC-IN
BLACK GND
WHITE MIC-POWER
GREEN LINE OUT FR
BROWN LINE OUT RR
YELLOW LINE OUT FL
AUDIO
BLUE LINE OUT RL

X-QPACK Addendum
System Guidelines:
1. Your CPU cooler should not exceed 76mm in height.
2. The X-QPack can accommodate graphics cards up to 254mm
in length.
3. The power supply dimensions are:114mm x 148mm x 84mm.
The PSU can be replaced with most standard ATX power
supplies provided that your optical drives do not exceed
172mm in length. Keep in mind that it will be a tight fit.
Changing the LCD display mode:
Our LCD temperature displays use Celsius as the default setting,
as is used on Intel/AMI motherboards. If you would prefer to
display system temperatures in Fahrenheit, you must set the LCD
switch to the "F" position. The switch is located on the PC board
at the rear of the LCD.
Removing the front panel:
With the 3-sided panel removed, locate the four screws that
secure the front panel. Unscrew each of them and unhook the four
clasps to remove. Use caution when handling panel wires.