Aqara M1S User manual

01
Product Introduction
Aqara Hub M1S is a smart home control center, which connects Zigbee
devices to Wi-Fi network. At the same time, it can manage and control
smart scenes, and can conveniently control smart devices, such as
plug, switch, bulb, curtain and so on.
Button
Single Press: Turn on/off night light
Long Press (10 seconds):
Reset thenetwork connection
Press 10 times: Restore the
factory default settings
Audio Output
Night Light
* For more details about Aqara products, please visit www.aqara.com

02
Quick Setup
Scan the QR code, or search for "Aqara Home" in the app store.
Download and install the Aqara Home app.
If you want to use the Mi Home app, please restore the factory
settings, and then press the button twice within 10 seconds aer you
hear the voice prompt "Ready to connect. Please open the Aqara
Home app". You can then add the hub using the Mi Home app.
1. Download the app

03
2
2. Add Hub M1S
Plug the hub into the socket and wait until the yellow light blinks
quickly. Make sure your mobile Phone is connected with 2.4 GHz
Wi-Fi network.
Please open the Aqara Home app, click “+” in the upper right
corner, select “Hub M1S” and follow the instructions to complete
adding the hub.
If you failed to add the hub, please press the button on the hub for
more than 10 seconds until the yellow light flashes quickly, and
then add it again.
*
*
If you are using a dual band router, please disable the 5 GHz Wi-Fi network.
Keep your phone close to the hub and make sure both of them are
connected with the same Wi-Fi network.
* iOS user: Follow the instructions to scan the product box or manually enter
the HomeKit code on the hub, and complete the setup. Once it is added
successfully, you can check the hub in the Apple Home app. Please keep the
HomeKit code in a safe place in case you need to add the hub again.
1
3

04
Aer the hub is connected, please open the Aqara Home app, go to
“Accessories” page and tap “+” in the top right corner, and select the
accessory to add to the hub according to instructions. Please refer to
bridge accessory quick start guide for more details.
3. Add bridge accessories
Installation
1.
2.
To ensure steady communication between the hub and its
accessories, it is recommended to install the hub at the center of
the area where the accessories are located.
Depending on the local environment, the indoor transmission
distance reaches up to 30 meters between the hub and bridge
accessories without barriers, such as walls.

05
Indicator Light Description
1.A customer who owns an Apple TV (4th generation or later) with
tvOS 10 or later, an iPad with iOS 10 or later, or a HomePod can
control HomeKit-enabled accessories away from home and
automatically through triggers such as time of day, location, sensor
detection, or the action of an accessory.
Indicator light status Hub status
Yellow light is always on Starting up
Yellow light flashes Waiting for network connection
Yellow or white light flashes Connecting to network
Purple light flashes Allowed to add the sub-device
Indicator light is off
White light is always on
Network configurations are not
completed within 15 minutes
aer start-up
Notice
Works normally or powered off