Aquadart venturi 6 AQ9349BLK User manual

Item Number:AQ9349BLK
Single Square Bath Screen
Tools Required
IMPORTANT
USE SAFETY EYE-WEAR WHEN DRILLING
Lifetime Product Guarantee
To activate your Product Guarantee please
visit www.aquadart.co.uk and complete
the online form.
6
PH2 TYPE
2.75
www.aprilproducts.co.uk
www.aprilproducts.co.uk
INSTALLATION INSTRUCTIONS
www.aquadart.co.uk
This product should be installed by a suitably qualified and proficient person. The fitting instructions should be
followed carefully to ensure a proper and safe installation. Failure to follow these instructions could result in future
injury.
These instructions and list of parts assume that installation is done against solid/tiled walls.
Please check this product for damage prior to starting the installation. No claims can be made after the product has
been fitted.
PLEASE NOTE :The minimum and maximum adjustment sizes noted on the product brochures are based on
perfectly plumb walls and trays.

Box Contents
COMPONENTS AND BOX CONTENTS
1
1
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1
2
2
1
2
1
1
3
Wall profile
Upright profile
Frame profile
Brush strip
Pivot Hinge
Screw cup
Wall plug
Hinge washer
Screws ST 4x30
Moving panel
Screw ST 4x30
SN
Screw cap
Screw ST3.5 x 10
Bottom Seal
SN Description Qty
Description Qty
3
3
3

A
B
C
D
Ф 6 drill bit
12-15mm
from bath
edge
4X45
Step 1: Position the wall profile (1) onto the bath , approximately 12-15mm from the outside bath edge to ensure that
the screen runs along the inside edge of the bath rim. (A).
Step 2: Level the profile with a spirit level , then mark the position using a pencil. Mark through the 3 pre-drilled screw
holes in the wall profile then drill the marked points using a 6mm masonry drill bit ,once this is done insert 3 wall plugs
(10) into the wall holes (B).
NOTE :You may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3: Secure the wall profile using 3 x ST4X30 screws (11). (C)
Step 4 : Carefully position the screen into the wall profile. (D)
Step 5 : Secure to the wall profile using 3 x ST3.5X10 screws (12) and cover caps (13,14) (E,F)
E
Ф2.75 drill bit

G
Bottom seal
NOTE : To ensure a watertight seal drop the silicone at the end of the bottom seal (9) (diagram h),also ensure the
bottom seal is fully inserted into the base of the hinge as per the above diagram.
H
24 HRS
Silicone the outside of the
vertical wall post and also the
outside of the bottom of the
wall post as diagram shown
below.

o
Riverside Business Park,Royd Ings Avenue,Keighley, West Yorkshire,BD21 4AF
01535 613830 Technical:01535 613830 Fax: [phone]