Aquadart Venturi 8 User manual

www.aprilproducts.co.uk
www.aprilproducts.co.uk
Item Number:AQ6000/AQ6001
INSTALLATION INSTRUCTIONS
Tools Required
IMPORTANT
USE SAFETY EYE-WEAR WHEN DRILLING
6
PH2 TYPE
2.75
Bath Screen
www.aquadart.co.uk
This product should be installed by a suitably qualified and proficient person. The fitting instructions should be
followed carefully to ensure a proper and safe installation. Failure to follow these instructions could result in future
injury.
These instructions and list of parts assume that installation is done against solid/tiled walls.
Please check this product for damage prior to starting the installation. No claims can be made after the product has
been fitted.
PLEASE NOTE :The minimum and maximum adjustment sizes noted on the product brochures are based on
perfectly plumb walls and trays.

Box Contents
COMPONENTS AND BOX CONTENTS
1
1
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
3
3
1
1
1
1
3
3
Wall profile
Upright profile
Frame profile
Vertical seal
Profile Top cap
Screw cover cap
Cap
Bottom seal
Pivot part 1
Pivot part 2
Pivot part 2
Wall plug
SN
Screw ST3.5 X 10
Screw ST4 X 45
Moving panel
SN Description Qty
Description Qty
3
3
3

A
B
C
D
Ф 6 drill bit
12-15mm
form bath
edge
4X45
Step 1: Position the wall profile (1) onto the bath , approximately 12-15mm from the outside bath edge to ensure that
the screen runs along the inside edge of the bath rim. (A).
Step 2: Level the profile with a spirit level , then mark the position using a pencil. Mark through the 3 pre-drilled screw
holes in the wall profile then drill the marked points using a 6mm masonry drill bit ,once this is done insert 3 wall plugs
(11) into the wall holes (B).
NOTE :You may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3: Secure the wall profile using 3 x ST4X45 screws (12). (C)
Step 5 : Carefully position the screen into the wall profile. (D)
Step 6 : Secure to the wall profile using 3 x ST3.5X10 screws (13) and cover caps (14,15) (E,F)
E
Ф2.75 drill bit

G
Allow 24 hours before use
for silicone to set .
For cleaning instructions
see guarantee .
Bottom seal
NOTE : To ensure a watertight seal,put a little bit of silicone at the end of
the bottom seal edge(diagram J) then ensure the bottom seal (10) is fully
inserted into the base of the hinge as per the above diagram(I).
I
H
I J

o
Riverside Business Park,Royd Ings Avenue,Keighley, West Yorkshire,BD21 4AF
01535 613830 Technical:01535 613830 Fax: [phone]

Check out our full range of Shower Enclosures
Quadrant Shower Enclosures
Corner Entry Shower Enclosures
Walk in Shower Enclosures
Sliding Shower Doors
Bifold Shower Doors
Pivot Shower Doors
Hinged Shower Doors
Shower Screens
From Top Brands
Coram Shower Enclosures
Mira Shower Enclosures
Hydrolux Shower Enclosures
Diamond Shower Enclosures
With quality shower trays to match your enclosure
Square Shower Trays
Rectangular Shower Trays
Quadrant Shower Trays
Coram Shower Trays
Mira Flight Shower Trays