Aquadart Venturi 6 AP9575 User manual

www.aprilproducts.co.uk
www.aprilproducts.co.uk
INSTALLATION INSTRUCTIONS
Tools Required
IMPORTANT
USE SAFETY EYE-WEAR WHEN DRILLING
6
PH2 TYPE
2.75
www.aquadart.co.uk
This product should be installed by a suitably qualified and proficient person. The fitting instructions should be
followed carefully to ensure a proper and safe installation. Failure to follow these instructions could result in future
injury.
These instructions and list of parts assume that installation is done against solid/tiled walls.
Please check this product for damage prior to starting the installation. No claims can be made after the product has
been fitted.
PLEASE NOTE :The minimum and maximum adjustment sizes noted on the product brochures are based on
perfectly plumb walls and trays.
Mini Bath Screen

Box Contents
COMPONENTS AND BOX CONTENTS
1
1
1
1
2
3
4
5
1
3
Wall profile
Upright profile
Profile Top cap
Wall plug
Glass panel
SN Description Qty
6
7
83
3
Screw cover cup
Cap
Screw ST3.5 X 10
Screw ST4 X 30
3
3
9
Fixing Kit
Wall profile top cap
x1
Wall plug
x3
Screw ST 4x30
x3
Screw ST 3.5x10
x3
Screw Cup
x3
Screw Cap
x3
IMPORTANT - Missing Components
Please check this product for missing components prior to installation.
For spare parts visit www.aquadart.co.uk
IMPORTANT - Installation site
1. Ensure the top surface of the bath on which the enclosure will be installed is level in every direction.
2. The tiles or other wall finishing should be effectively sealed at bath edges.
3. Tiles should extend at least to the corner of the bath.

A
B
C
Ф 6 drill bit
12-15mm
from bath
edge
4X45
Step 1: Position the wall profile (1) onto the bath , approximately 12-15mm from the outside bath edge to ensure that
the screen runs along the inside edge of the bath rim. (A).
Step 2: Level the profile with a spirit level , then mark the position using a pencil. Mark through the 3 pre-drilled screw
holes in the wall profile then drill the marked points using a 6 mm masonry drill bit ,once this is done insert 3 wall plugs
(5) into the wall holes (B).
NOTE :You may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3: Secure the wall profile using 3 x ST4X45 screws (6). (C)
Step 5 : Carefully position the screen into the wall profile. (D)
Step 6 : Secure to the wall profile using 3 x ST3.5X10 screws (8) and cover caps (7,9) (E,F)
Ф2.75 drill bit
D
E
F

Allow 24 hours before use
for silicone to set .
For cleaning instructions
see guarantee .
G
I
H

o
Riverside Business Park,Royd Ings Avenue,Keighley, West Yorkshire,BD21 4AF
01535 613830 Technical:01535 613830 Fax: [phone]