Argos FWA00161C User manual

Dimensions
Width - 100cm
Depth - 170cm
Height - 75cm
Issue 1 - 26/05/10
Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08450 778 888
Assembly Instructions - Please keep for future reference
Panama Dining
Table
168/9987
Important –

This product is
manufactured from
toughened safety glass.
In the unlikely event that
the glass fails it will break
in to a large number of
small fragments that may
be spread over a wide
area. This is a feature of
toughened glass,
designed to remove the
risk of injure from glass
breaking into large shards.
If the glass is chipped
or broken, stop using the
product and consult the
manufacture or supplier.
Check you have all the
components and tools
listed on page 2.
Remove all fittings from
the plastic bags and
separate them into their
groups.
Keep children and
animals away from the
work area, small parts
could choke if swallowed.
Make sure you have
enough space to layout
the parts before starting.
Do not stand or put
weight on the parts during
assembly, this could
cause damage.
Assemble on a soft
level surface to avoid
damaging the unit or your
floor.
Dispose of all packing
carefully and responsibly.
Do not sit or stand upon
horizontal glass surface.
Do not place very hot or
very cold items on the
glass unless adequately
thick tablemats are used to
prevent such items from
coming into contact with
the glass. The unit
weights approximately
kgs.
Warning:
Please lift with care.
Wash frame parts with
mild soap and water, rinse
thoroughly, and dry frame
completely. Do not use
bleach, acid, or other
solvents on the frame
parts.
Wash glass with mild
soap and water, rinse
thoroughly, and dry glass
completely.
When moving the table,
remove the umbrella. Do
not drag.
We recommend the use
of furniture covers when
not in use.
Do not use the glass as
chopping surface. Do not
strike the glass with hard
or pointed items.
In order to prolong the
life and beauty of your
table, we recommend it be
stored in a dry and
protected area during off
season periods.
Do not use washing
powders or any abrasive
substances which may
scratch the surface.
38.2

Components - Parts
Please check you have all the parts listed below
2
Table leg x 4
2
Short panel x 2
4
Table top x 1 ( 170 x 100 cm)
1
3
Long panel x2
5
Glass x1 ( 161 x 91cm)
Components - Fittings
If you have damaged or missing components,
call the
Customer Helpline: 08456 778 888
Plastic center plug x 1
Note:
The quantities below are the correct amount to complete the assembly. In some cases more
A
Plastic cap x 24
C
Metal washer x 24
B
ED
Allen key x 1
15mm Screw x 24
fittings may be supplied than are required.
Please check you have all the fittings listed below

Assembly Instructions
Step 1
Assembly frame
Step 2
Important:
Do not fully
tighten all screws
until assembly is
complete.
B
B
A
A
A
B
C
A
B
A
C
B
4
2
4
1
1
2
2
2
3
3
A
A C
B
3
Use 15mm screw and
metal washer to fix
4 table legs 2 to long and
short panels 3 & 4 .
Use15mm screw and
metal washer to fix
table top 1 to table legs
2 . Tighten the screw
and seal them with
plastic cap .

Assembly Instructions
4
Step 3
Step 4
5
D
If you need help or have damaged or missing parts, call the Customer Helpline: 08450 778888
Homebase
Limited
489-499 AveburyBoulevardSaxon GateWestCentralMiltonKeynesBucks,MK9 2NW
Assembly is complete.
Turn the table top 1 to
its upright position and put
on the glass 5 .
insert the plastic center
plug Dinto the center of
the glass 5 .

Dimensions
Width - 100cm
Depth - 170cm
Height - 75cm
Issue 1 - 26/05/10
Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08450 778 888
Assembly Instructions - Please keep for future reference
Panama Dining Table
168/9987
Important –

This product is
manufactured from
toughened safety glass.
In the unlikely event that
the glass fails it will break
in to a large number of
small fragments that may
be spread over a wide
area. This is a feature of
toughened glass,
designed to remove the
risk of injure from glass
breaking into large shards.
If the glass is chipped
or broken, stop using the
product and consult the
manufacture or supplier.
Check you have all the
components and tools
listed on page 2.
Remove all fittings from
the plastic bags and
separate them into their
groups.
Keep children and
animals away from the
work area, small parts
could choke if swallowed.
Make sure you have
enough space to layout
the parts before starting.
Do not stand or put
weight on the parts during
assembly, this could
cause damage.
Assemble on a soft
level surface to avoid
damaging the unit or your
floor.
Dispose of all packing
carefully and responsibly.
Do not sit or stand upon
horizontal glass surface.
Do not place very hot or
very cold items on the
glass unless adequately
thick tablemats are used to
prevent such items from
coming into contact with
the glass.
The unit
weights approximately
Warning:
Please lift with care.
Wash frame parts with
mild soap and water, rinse
thoroughly, and dry frame
completely. Do not use
b leach, acid, or other
solvents on the frame
parts.
Wash glass with mild
soap and water, rinse
thoroughly, and dry glass
completely.
When moving the table,
remove the umbrella. Do
not drag.
We recommend the use
of furniture covers when
not in use.
Do not use the glass as
chopping surface. Do not
strike the glass with hard
or pointed items.
In order to prolong the
life and beauty of your
table, we recomm end it be
stored in a dry and
protected area during off
season periods.
Do not use washing
powders or any abrasive
substances which may
scratch the surface.
37.5kgs.

Components - Parts
Please check you have all the parts listed below
2
Table leg x 4
2
Short panel x 2
4
Table top x 1
1
3
Long panel x 2
5
Glass x 1
Note:
The quantities below are the correct amount to complete the assembly. In some cases more
A
Plastic cap x 24
C
Metal washer x 24
B
ED
Allen key x 1
15mm Screw x 24
fittings may be supplied than are required.
Please check you have all the fittings listed below
Plastic support x 18
(Have already fixed on the table rim)
Components - Fittings