Argos Phoenix 314/9449 User manual

Assembly Instructions - Please keep for future reference
-
314/9449
Dimensions
Width - 70cm
Depth - 35.5cm
Height - 175cm
Important
Version 1 Date: 20/10/14
Phoenix 5 Shelf
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
- Please read these instructions fully before starting assembly
352/4600

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Do not use this item if any
components are missing or
damaged.
• Parts of the assembly will be
easier with 2 people.
• During assembly children
should be kept away from the
product due to possible risk of
injury.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints
• Argos Ltd. MK9 2 NW. • This product is intended for
children in the age range of
7-12 years.
• Maximum load: 10 kgs for
each shelves.
• Assembly of this product must
be carried out by a competent
adult.
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800
2
Top / Bottom panel x 2
(69.9 x 34.9cm)
1
Right / Left side panel x 2
(171.6 x 34.9cm)
3
Shelf x 4
(66.8 x 34.9cm)
2
Top back panel
(69 x 69.5cm)
4
Bottom back panel
(69 x 104.6cm)
5

A B C
D
G
E F
3
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Components - Fittings
Wall strap x 1
H
Allen key x 1
Wall plug x 1
14mm Screw x 1
30mm Dowel x 16
Nail x 44
Screw cover x 2450mm Screw x 24
x 1
(This screw is
included in the
wall strap bag)

4
Assembly Instructions
Step 1
Fitting dowels and
screws
b: Fasten Screws(8 pcs)
by Allen key to fix
Right / Left side panel
onto the Shelves .
3
2
b:
a:
c:
BH
Use Screw covers to
cover the screw heads.
C
X 4
Insert Dowels into the
Shelf .
A
22
2
3
3
2
2
2
2
2
2
2
c: Fasten Screws(8 pcs)
by Allen key to fix
Right / Left side panel
onto the unit.
3
B H
Use Screw covers to
cover the screw heads.
C
Unfinished back edge
Unfinished
back edge
C
B
C
B
C
BC B
C
B
C
B
C
B
C
B
C
B
C
A
A
A
A
B
C
B
C
B
C
B
C
B
C
B
C
B
C
B
3
B
H
3
B
H

Assembly Instructions
Step 2
Step 3
Attach Top back panel
and Bottom back panel
using nails .
D
4
5
Fixing back panel
Important:
The unit MUST
be ‘square’ when
back is attached.
3
1
5
4
1
Use Screw covers to
cover the screw heads.
C
5
Attaching top and
bottom panels
Fasten Screws(8 pcs)
by Allen key to fix
Top / Bottom panel
onto the unit.
1
B H
Unfinished
back edge
Unfinished
back edge
Unfinished
back surface
D
C
C
C
C
B
B
B
B
C
C
C
B
B
B
1
B
H

6
Assembly Instructions
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Top panel
wall
E
F
G
GG G F
Note: Wall plugs supplied are
for solid wall only.
be used for your wall, seek
professional advice if in doubt.
Step 4
Assembly is complete.
It is recommended that
the unit is fixed to a wall.
With help, move the unit
into position.
Fixing to wall
Fix Wall strap to top
panel using Screw .
Mark fixing hole on wall
and remove unit.
Drill a hole and insert Wall
pulg .
Reposition the unit and fix
wall strap using Screw .
Warning:
Before drilling,
check wall for
hidden pipes
and cables.
Warning:
The unit is heavy.
Lift with care.
G
E
F
G

A Guide to - Wall Mounting & Fixings
Revision 2 - 7/10/09
Important note:
Types of walls
Care &
Maintenance
No.1 “General Purpose” wall plug
No.6 “Shield Anchor” wall plug
Heavy loads
No.3 “Cavity Fixing” wall plug
No.4 “Cavity Fixing-Heavy Duty”
wall plug
No.5 “Hammer Fixing” wall plug
No.2 “Plasterboard” wall plug
Generally aerated blocks should not
be used to support heavy loads, use
loads, general purpose wall plugs can
be used.
For use with heavier loads such as TV
& HiFi speakers and satelite dishes etc.
For use with plasterboard partitions or
hollow wooden doors.
heavy loads such as shelving, wall
cabinets and coat racks.
For use with walls stuck with
is secure to the retaining wall.
For use when attaching light loads on
to plasterboard partitions.
Safety: Always check the fitting
and location to ensure your safety
in and around the home.
Fitting: From time to time check
the fitting to ensure the wall plugs
or screws do not become loose.
You can use one of the following types of wall plug if your walls are made
of brick, breeze block, concrete, stone or wood.
Important: When drilling into walls always
check that there are no hidden wires or pipes etc.
Hints:
1: General rule: Always use a larger screw and wall plug
if you are not sure.
2: Ensure you use the recommended drill bit to match the wall
plug and hole size.
3: Ensure you drill the hole horizontally, do not force the drill or
enlarge the hole.
4: Take extra care when drilling high walls, ceilings and ceramic
tiles. Ensure wall plugs are inserted beyond the thickness of
the ceramic tiles to avoid the tiles splitting or cracking.
5:
drilled hole.
If plastic wall plugs
are supplied with your
product:
Make sure that the screws and wall plugs being used
are suitable for supporting your unit. Consult a qualified
tradesperson if you are unsure.
- these are only suitable for
use in masonry walls.
If you are in any doubt about
the correct wall plugs for
your wall, seek professional
advice.
Failure of the product due to
responsibility of the installer.