Argos Wide Media Unit Installation guide

Assembly Instructions - Please keep for future reference
Dimensions
Width - 60.5 cm
Depth - 19.6 cm
Height -113 cm
Important - Please read these instructions fully before starting assembly
issue 05/08/15
457/2156
Wide Media Unit
If you need help or have damaged or missing parts, call the Customer Helpline
Argos = 0345 6400800
625/9563
651/5070
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

1
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
the following pages.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
During assembly do not stand
or put weight on the product,
this could cause damage.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Parts of the assembly will be
easier with 2 people.
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
●From time to time check that
there are no loose screws on
this unit.
●This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Handy Hints
Regularly check and ensure
•
that all bolts and fittings are
tightend properly.
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Components - Panels
Please check you have all the panels listed below
2
If you have damaged or missing components,
call the Customer Helpline Argos = 0345 6400800
Bottom panel x 1 (60.5 x 19.6cm)
2
Top panel x 1 (60.5 x 13.1cm)
1
Shelf panel(use dowel) x 4 (58 x 12.9cm)
6
Left Side panel x 1 (111 x 13cm)
3
Right Side panel x 1 (111 x 13cm)
4
Middle Shelf x 3 (15 x 12.8cm)
8
Shelf panel(use screw) x 1 (58 x 12.9cm)
5
Back panel x 2 (113 x 30.2cm)
7
Middle Shelf x 6 (20 x 12.8cm)
9
Unfinished edge
Unfinished edge
Unfinished edge
Unfinished edge
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

The screws length is measured from the head to the point (30mm
screw shown).
C
Components - Fittings
Please check you have all the fittings listed below
30mm dowel x 56
Tools required
Ruler - Use this ruler to help correctly identify the screws
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
38mm Screw x 12
A
D
Nail x 38
3
B
E
Stickers x 8
Wall strap x 2
J
H
Wall plug x 2
F
26mm Screw x 2
Phillips screwdriver
(medium & large)
Ruler/tape
measure
hammer.)
G
12mm Screw x 2
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
Step 1
Insert dowels
a:
3
Step 1
a: Insert dowel into
middle panels .
4
b: Insert dowel
into shelf panel and
side panel .
b:
GB
9
8
B
6
8
9X6
X3
4
6
6
6
6
B
BB
B
B
B
B
B
B
B
B
B
BX 16
3 4
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
Step 2
Attaching panels
a:
Step
a: Attaching panel
using dowel
as shown. Attention to
the position of shelf
.
5
9
8
6
5
6
6
6
9
9
9
9
9
8
8
Finished edge
6
5
89
5
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
Step 2
Attaching panels
Step
b: Attaching the side
panels with
screw .
b:
6
4
3
A
A
A
A
C:
A
A
A
A
1
c: Attaching the top
panel onto unit
with screw .
34
1
A
A
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
Attaching panel
d:
Lift with care.
Step 2 Step
d: Attaching the
bottom panel onto
unit with screw .
a: Turn the unit up
side down.
2
A
7
A
A
A
A
2
Step 3 Step
Attaching back panels a:
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
b:
b: Attaching the back
panel . One piece
first, using nail .
Don’t put the nail too
close to the corner to
avoid the screw
penetrate the panel.
Step 3 Step
Attaching back panels
c: Fix the another back
panel onto the unit
using nail .
8
suggest to add a nail
in the middle of the back panel
to reinforce the structure
c:
7
7
7
C
7
C
C X 38
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D

Assembly Instructions
9
Step 3 Step
Attaching back panels d:
d: Fit the wall strap
onto the back of unit
with screw .
H
Step 4 Step
Paste sticker
Paste sticker onto
the screws on top panel
and side panels.
1
4
F
H
H
F
F
D
D
D
D
D
Wall strap x 1
F
I
Double side cam bolt x 1
4
3
GG
G
GG
7
C
D