Argos 484/2831 User manual

IMPORTANT
SLIDING MIRROR DOOR CABINET
Simple Assembly Instructions Page 1
GDoor Knob x 2
ABase x 1
CTop with blocked
runners x 1
BSide x 2
HWasher x 2
IDoorknob
Screw x 2
F
Glass
Door x 2 NWall plug x 2
J40mm Screw x 8
M50mm Screw
x 2
KCap x 8
LShelf Support
x 4
1. Read these instructions
carefully and familiarise
yourself with the
procedures.
2. Check that you have all
the component parts
and fittings listed below
and familiarise yourself
with each part before
proceeding.
3. To avoid scratching it is
recommended that you
assemble the cabinet
on a soft level surface.
COMPONENT PARTS AND FITTINGS
DBack x 1
EShelf x 1

Assembly Instructions Page 2
fig. 3
fig. 4
fig. 6
fig. 1
fig. 2
K
J
B
B
B
B
A
A
A
Slots for
Back Panel
D
Screw holes
for wall fixing
Holes for
fixing to wall
D
C
fig. 5
B
B
Caps
covering Screw
J
K
L
THE FRAME
1. Take Base and secure it to Side
using Caps and Wood Screws
(See figs 1 and 2).
2. Attach the second Side to Base
in the same way (See figs 1 and 3).
3. Next, slide Back down into the
grooves making sure that the screw holes
are at the top (See figs 3 & 4).
4. Fix Top to the two sides in the
same way as the base (See figs 1, 3
and 5).
5. There are two positions for Shelf .
When you have decided, push the four
Shelf Supports into the relevant holes
(See fig 5). DO NOT FIT THE SHELF
AT THIS STAGE.
Before fitting the doors, it is
recommended that you fix the
cabinet to the wall.
WALL FIXING
1. Hold the cabinet against the wall with the
help of a second person. Having made
sure it is horizontal, mark the wall through
the two holes in Back Panel
(See fig 6). Using the marks, drill two
holes in the wall and insert the
Wall Plugs .
2. Fix the cabinet to the wall with Screws .
IMPORTANT
When drilling into walls be certain
that there are no hidden wires,
pipes etc. You must also make sure
that the screws and wall plugs supplied
are suitable. If in doubt consult
a qualified tradesman.
3. Place the Shelf in position.
MAKE SURE THE CABINET IS SECURE
E
M
N
D
L
E
B
C
D
A
B
J
K
B
A

Assembly Instructions Page 3
FITTING DOOR KNOBS
1. Fit Screw into Washer and push
it through the hole in the back of the
Glass Door . Then carefully screw
the Doorknob on the glass side
of the door. (See fig 7).
FITTING THE DOORS
1. Take the left door and fit the top edge
into the back runner in top . Then let
it drop down into the back runner in
Base (See figs 8, 9 & 10).
2. Repeat this operation with the right hand
door using the front runners (See fig 10).
3. Carefully open and close the doors
to make sure they are seated correctly
in the runners.
A
C
G
F
H
I
Left hand door
in back runner
View of cabinet top
fig. 8
fig. 9
fig. 10
fig. 7
F
F
I
H
G
Back of
glass door
Right hand door
in front runner