ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074153-INS-RB • PAGE 2
Step 1
Starting on the driver side, locate
the three mounting locations
underneath the vehicle.
Step 2
With help, lift the rocker step into
position and align the brackets on
the rocker step with the mounting
points on the vehicle.
Secure the front mounting location to the
vehicle with two M8 hex bolts, two lock
washers and two flat washers.
Snug the hardware,
but do not fully tighten.
Step 3
Repeat step 2 to secure the middle and
rear mounting locations to the vehicle.
Tighten all hardware to the
recommended torque specifications
listed in the table on the first page.
Step 4
Repeat steps 1 through 3 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.
