Aries 2051101 User manual

PAGE 1 • 2051101-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For stainless steel, polish may be used to clear small scratches
and scuffs on the finish. Mild soap may be used also to clean the product.
For black finishes, mild soap may be used to clean the product.
Level of Difficulty
Easy
INSTALLATION MANUAL 2051101
Scan
for helpful
install tips
Product Image
Front Front
Rear Rear
Parts List
1Driver / left, running board
1Passenger / right, running board
2Mounting bracket, front
2Mounting bracket, middle
2Mounting bracket, rear
24 Hex head bolt, 8mm
24 Flat washer, 8mm
24 Lock washer, 8mm
12 Hex nut, 8mm
Tools Required
Ratchet Socket, 13mm
Extension

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2051101-INS-RA • PAGE 2
Step 1
Starting on the driver-side, locate
the three mounting locations and the
front bracket for the driver side.
Step 2
Locate the front two threaded mounting
locations. Place the front bracket up to
the vehicle and secure it using two 8mm
hex bolts, two 8mm lock washers and
two 8mm flat washers.
Step 3
Repeat step 2 to install the middle and
rear brackets over the mounting hole
locations from step 1.
Step 4
Remove the flat washers, lock washers
and hex nuts from the running board.
Carefully place the running board
onto the mounting brackets.
Slide each hex bolt into the appropriate
slot on the mounting bracket.

PAGE 3 • 2051101-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Step 5
Attach the running board to the brackets
using six 8mm lock washers, six 8mm
flat washers and six 8mm nuts.
Snug the hardware,
but do not fully tighten.
Step 6
Adjust the running board, centering
it between the front and rear wheel wells.
With the running board in position, it is
recommended that all brackets first be
tightened to the vehicle, followed by the
running board connections.
Step 7
Repeat steps 1 through 6 on the
passenger side of the vehicle.
Congratulations on the installation
of your brand new ARIES AeroTread™
running boards.
With the running boards installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
first page of this instruction manual.