Aries 2081205 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 1
Parts List
1Driver / left corner
1Passenger / right corner
8Socket cap screw, M6
8Flat washer, M6
8Nylock nut, M6
6Hex bolt, M10
12 Flat washer, M10
6Lock washer, M10
6Nut, M10
2LED work light (#1501250)
1Rubber gasket
INSTALLATION MANUAL CORNER
WITH LEDS
Torque Specifications
M6 bolt 7 ft-lbs.
M8 bolt 16 ft-lbs.
M10 bolt 33 ft-lbs.
M12 bolt 58 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Phillips screwdriver
Socket extension Flathead screwdriver
Socket set Allen wrench set
Level Box wrench set
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Photo
Applicable to the Following Part Numbers
2081205 2081200
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.
This is the second of two manuals
required to complete this installation. The
first manual is included with your center
section. If installing a brush guard, there
will be a third manual required.
Level of Difficulty
Easy

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 2
Step 1
Set the corners onto a flat work
surface. Insert the rubber gasket
and LED light into place as shown.
Secure the four LED light attachment
points with an M6 socket cap screw,
flat washer and nylock nut at each point.
Tighten all hardware and repeat
for the second corner and light.
Step 3
With both corners loosely installed,
check to make sure the edges of the
bumper corners and center section align.
Adjust if necessary and fully tighten all
hardware with a 16mm socket and wrench.
Note: If installing a brush guard, refer to the
brush guard installation manual at this time.
Note: If you are not installing a brush
guard, continue to step 7 of the manual
included with your center section.
Step 2
Place the center section onto a flat work
surface. Lift the bumper corner into place
and insert an M10 hex bolt, lock washer
and flat washer. Secure the bolt with a
second flat washer and a hex nut.
Repeat this step for all
three attachment points.
Snug the hardware,
but do not fully tighten.
Repeat this step on the opposite side.