Aries 2055122 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •844.278.4357 •2055122-INS-RD •PAGE 1
INSTALLATION MANUAL 2055122
Parts List
4VersaTrac™mounting bracket, universal
12 Flat washer, M8 (S)
12 Lock nut, M8 (S)
8Hex bolt, M8 (B)
8Flat washer, M8 (B)
8Lock washer, M8 (B)
8Hex nut, M8 (B)
8Nylon flat washer, M8
(S) = Silver hardware, (B) = Black hardware
Running boards / side steps sold separately
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Socket set
Torque wrench Socket extension
Level --
Level of Difficulty
Easy
Product Photo
Front
Rear
This is the first of two manuals
required to complete this installation.
The second manual is included with
your running boards / side steps.
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •844.278.4357 •2055122-INS-RD •PAGE 2
Step 1
Starting on the driver side, locate
the two mounting tabs along the
bottom edge of the vehicle body.
Step 2
Starting at the front driver-side mounting
location, locate the three threaded bolts
on the inside of the body panel.
Before attaching the bracket, place a
nylon flat washer on each of the threaded
bolts to prevent any galvanic corrosion.
Attach the bracket to the body panel
using a silver M8 flat washer and lock nut.
Snug the hardware,
but do not fully tighten.
Step 3
Repeat step 2 to install the second
bracket over the rear mounting tab
location from step 1.
Repeat steps 1 through 3 on
the passenger side of the vehicle.
Note: To complete the installation,
refer to the manual included with
your running boards / side steps.