Aries S223015 User manual

PAGE 1 • S223015-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Brackets and Hardware
Notes and Maintenance
Before you begin installation, read all instructions thoroughly
Proper tools will improve the quality of installation and reduce the time required
To protect the product, wax after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may
contain abrasives that could damage the finish.
For gloss black finishes, mild soap may be used to clean the product.
Level of Difficulty
Easy
Parts List
1Driver / left side bar
1Passenger / right side bar
1Driver / left front bracket
1Passenger / right front bracket
1Driver / left rear bracket
1Passenger / right rear bracket
24 Hex bolt, 10mm x 35mm
8Hex nut, 10mm
24 Lock washer, 10mm
32 Flat washer,
10mm ID x 30mm OD x 1.5mm
8Clip nut, 10mm
INSTALLATION MANUAL
S223015
Tools Required
Ratchet 17mm socket
Level Tape measure
Wrench, 17mm
Scan
for helpful
install tips
Front
Rear

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • S223015-INS-RA • PAGE 2
Step 1
Starting on the driver side, locate the
three mounting locations along the body.
This installation will use the front and rear
mounting points.
Step 2
The mounting brackets are specific to
a front or rear mounting location. When
mounting the brackets, have the cradle
facing toward the middle of the truck for
proper placement.
Step 3
Starting at the front, remove the factory
tape or plug covering the mounting holes
on the inner rocker panel.
Insert a 10mm clip nut onto each
mounting point.
Step 4
Lift the bracket into place and attach
with a 10mm hex bolt, locking washer
and flat washer into the rocker panel
and mounting tabs.
Snug the hardware,
but do not fully tighten.

PAGE 3 • S223015-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Step 5
Repeat this for the passenger side
bracket.
Step 6
To determine the front of the side bar,
measure from the end of the side bar
to the center of the rivet nut. This
measurement should be 15 1/2".
Step 7
Lift the new side bar into place and
attach with a 10mm bolt, locking washer
and flat washer.
Step 8
Check for level and adjust if necessary.
Once aligned, tighten all hardware.

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • S223015-INS-RA • PAGE 4
Step 9
Repeat this entire process on the
passenger side.
Step 10
Remember to do periodic inspections
to make sure that all hardware is secure
and tight.
To protect your investment, we
recommend you apply a layer of
nonabrasive wax.
Congratulation on the installation of
your brand new ARIES 4" oval side bars.