Aries 2074141 User manual

PAGE 1 • 2074141-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Parts List
1Driver / left rocker step
1Passenger / right rocker step
12 Hex bolt, M8 - 1.25 x 30mm
6Flat washer, M8 x 16mm OD
6Flat washer, M8 x 24mm OD
12 Lock washer, M8
6Lock nut, M8
Tools Required
Torque wrench Socket, 13mm
Extension Level
Scan
for helpful
install tips
Front
Rear
INSTALLATION MANUAL 2074141
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074141-INS-RA • PAGE 2
Step 1
Starting on the driver-side,
locate the four mounting locations
underneath the vehicle.
Step 2
With help, lift the driver-side rocker step
up to the vehicle. Align the mounting
holes on the rocker step with the
mounting points on the vehicle.
Secure the lower rocker step mounting
tabs to the vehicle using M8 hex head
bolts, M8 x 16mm flat washers and M8
lock washers. Secure the larger top
rocker step mounting tabs using M8 hex
head bolts, M8 x 24mm flat washers and
M8 lock washers.
Note: On older model vehicles with an
M8 stud in the top mounting position,
secure the top mounting tabs with
M8 x 24mm flat washers, M8
lock washers and M8 - 1.25 hex nuts.
Tighten all hardware.
Step 3
Repeat steps 1 through 2 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed,
periodic inspections should be
performed to ensure all mounting
hardware remains tight.