Aries S225044 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •S225044-INS-RB •PAGE 1
INSTALLATION MANUAL S225044
Parts List
1Driver / left running board
1Passenger / right running board
6Mounting bracket, universal
12 Hex bolt, M10
12 Flat washer, M10
12 Lock washer, M10
18 Nylock nut, M8
18 Flat washers, M8
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Torque wrench
Socket set Level
Level of Difficulty
Easy
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Photo
Brackets and Hardware
Front
Front
Middle
Rear
Rear
Product Registration
CURT Group stands behind our
products with industry leading
warranties. You can help us continue
to improve our product line and
help us understand your needs by
registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king.
We value your feedback and we use
that information to make improvements
on our products. Please, take a minute
and let us know how we are doing.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •S225044-INS-RB •PAGE 2
Step 1
Beginning on driver side, locate
the three mounting tabs along the
bottom edge of the vehicle.
Step 2
Starting at the front mounting location,
remove any debris from the factory studs.
Attach a mounting bracket using
an M8 nylock nut and flat washer.
Repeat this process for the
middle and rear mounting locations.
Snug the hardware,
but do not fully tighten.
Step 3
Place the driver-side side bar onto the
mounting brackets and align the mounting
points. Ensure the rivet nuts on the bottom
of the side bar line up with the brackets.
Secure the side bar to the brackets
using a M10 hex bolt, lock washer and
flat washer at each mounting location.
Snug the hardware,
but do not fully tighten.
Repeat steps 1 through 3 for the
front, middle and rear mounting
locations on the passenger side.
Step 4
Congratulations on the installation
of your new ARIES 4" oval side bars.
With the side bars installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.