ARJO HUNTLEIGH Auralis User manual

15 min
Auralis
2s
1
Assemble seat cushion and pump
Start the Auralis system
2
When the pump is connected to a
power source it runs a self check:
Beep - 10 seconds - 2 beeps - ready
to use.
Press and hold Run/Standby button.
The following indicators are shown:
• Run/Standby
• Wait indicator
• Alternating mode button
• Comfort control indicator
• Battery charge indicator
• Green indicators on the front of
the pump
Once the Wait indicator turns off,
place bed sheet on mattress. Make
sure that the CPR rapid deation
unit is clearly visible.
Place patient on the mattress or
seat cushion.
Alternating mode is set by default.
Assemble mattress overlay or mattress replacement and pump
CPR unit is clicked into
closed position.
“Click”
3
Connect the tubeset.
Zip the protective cover
over the mattress. Arjo
logo visible at the foot
end.
Auralis
2
Mattress overlay:
Place on top of base mattress.
Secure with 4 xing straps.
Mattress replacement:
Place on bed base.
Attach the 8 securing straps to
moving parts of bed frame.
• tubeset at foot end
• CPR at head end
• cells facing up
1
4 5 6
Hang the pump at the
foot end of the bed.
Place cable in the cable
management. Close the
ap around the cable with
the press studs.
Connect power cable to
power source.
“Click”
Seat cushion:
Place on chair surface.
Use the xing straps to attach.
Place pump on oor, cable under chair,
tubeset placed alongside chair.
Connect the tubeset.
Connect power cable to power source.
21
• cells facing up
• tubeset at front right corner
• cells horizontal across chair,
V-shape towards front
Front of chair
Back of chair
“Click”
08.AI.02EN_01 • 06/2020 • Page 1/2
QUICK REFERENCE GUIDE - USE
Auralis

2s
2s
Autorm mode
21
Activate: Press and hold
the button.
Comfort indicators ash
and mattress inates to
Autorm.
Extend:
Press button to extend 5
minutes. Max. 30 min.
If not extended, pump
goes back to previous
mode.
1 3
Deactivate: Press and
hold the button or select
another mode.
Pressure reached –
Autorm and Control
comfort indicators turn to
constant.
Transport mode (mattresses only)
2
1
Activate:
Press side buttons simultaneously and remove tubeset.
The mattress supports the patient for up to 12 hours.
Deactivate:
Reconnect the tubeset. The pump goes back to the
previous mode
CPR rapid deation unit
Activate: Press both CPR release
buttons simultaneously.
Reset: Press down the open part
until it clicks into closed position.
“Click”
Make sure the front part is open.
The air evacuates in 15 seconds.
“Click”
2s
2
Alternating mode, default setting
2
1
Activate:
Press button, the Alternating mode indicator is shown.
Adjacent cells inate and deate on a 10 minute cycle.
Deactivate:
Select Reactive CLP or Autorm mode.
If no further therapy is required, remove patient from
the surface and turn off the pump.
Reactive CLP mode
2
1
Activate:
Press and hold the button.
Reactive CLP mode indicator is shown.
Deactivate:
Select Alternating mode or Autorm mode.
If no further therapy is required, remove patient from
the surface and turn off the pump.
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com 08.AI.02EN_01 • 06/2020 • Page 2/2