ARJO HUNTLEIGH Maxi Sky 2 Plus User manual

2
Pull each leg strap under the thigh
so that it emerges on the inside of
the thigh.
1
Place the sling around the
patient. For sling with head
support extend to top of
patient’s head.
Place attachment loop on
the hook.
Make sure that the safety
latch is closed.
3
Loop sling
4
Place spreader bars at 45° and, close enough to attach
shoulder loops then the leg loops.
Raise foot-end of spreader bar first using the Recline
button to create tension on the leg loops.
The sling must encircle the patient's buttocks
to provide better support and to achieve a
proper installation
56
Raise the patient. Move the patient.
7 8
Lower until no tension. Detach the
leg loops, then shoulder loops.
001-31310-EN Rev 0 • 05/2020 • Page 1/4
QUICK REFERENCE GUIDE - USE
Maxi Sky 2 PLUS
Transfer from seated to supine position

1
Roll the patient onto their side. Fold the sling
in half and place it on the bed along the back
of the patient.
2
Roll the patient back onto the sling and then roll the
patient in the opposite direction, so that the folded
part of the sling can be straightened out.
5
Raise patient.
6
Move the patient.
Place attachment loop on the
hook.
Make sure that the safety latch
is closed.
3
Loop sling
4
Place spreader bar in flat position.
and close enough to attach the loops.
Connect the sling shoulder and leg loops to the
spreader bar.
7
Lower until no tension. Detach
the leg loops, then shoulder
loops.
001-31310-EN Rev 0 • 05/2020 • Page 2/4
Transfer from supine to seated position

Attach as many sling loops
as possible to the spreader
bar.
3
1
Place sling under the patient
and position the lift over the
patient.
4
Raise until hips are
supported and move up
or to the side.
Lower patient onto new
location and detach all
sling loops.
5
Place attachment loop
on the hook.
Make sure that the
safety latch is closed.
2
Loop sling
Place attachment loop
on the hook.
Make sure that the
safety latch is closed.
2
Loop sling
3
Attach as many sling loops as possible from
one side of the sling to the spreader bar.
Raise until patient is rolled into wanted
position.
Lower until no tension and
disconnect all loops.
41
Place sling under the patient and
position the lift over the patient.
Place spreader bars at 45° to attach
loops.
001-31310-EN Rev 0 • 05/2020 • Page 3/4
Repositioning - move up or to the side in bed
Repositioning - bed turning

4
Move patient toward the new
surface, position patient centrally
over the new surface.
5
Lower the patient onto the bed.
Lower the spreader bar farther down to detach the loops.
Raise the spreader bar and move the ceiling lift away from the patient.
Place attachment loop on
the hook.
Make sure that the safety
latch is closed.
2
Loop sling
3
Attach the loops to the spreader bar.
Raise the patient until the patient is fully
supported.
Position the lift close enough
to attach the loops.
1
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com
Lateral transfer - from or to adjacent flat surfaces
001-31310-EN Rev 0 • 05/2020 • Page 4/4