ASCOM teleCARE SB User manual

TD 92345GB
Installation Instructions
teleCARE M
Pull Cord Switch Module
Wall mounting
2005-06-16 / Ver. A Details subject to change without notice
123
4567

TD 92345GB
Installation Instructions
teleCARE M
Pull Cord Switch Module
Ceiling mounting
2005-06-16 / Ver. A Details subject to change without notice
123
4 5 6

TD 92345GB
Installation Instructions
teleCARE M Pull Cord Switch Module
2005-06-16 / Ver. A Details subject to change without notice
Mounting the backplate
When mounting the backplate on an
uneven surface, be sure not to bend
the backplate. Just use enough
pressure to tighten the screws without
bending the backplate.
Attaching the pull-cord module
Step 1: Place the bottom of the switch
module over the lower snap fittings of
the backplate.
Step 2: Hold the bottom of the switch
module in place while moving the top
towards the backplate until it locks
onto the upper snap fittings.
Because the pull-cord module is snap
fitted on top of the backplate, it is
possible that when excessive force is
used, the pull-cord module can be
pulled off of the backplate just before
the safety brake balls come apart. To
minimize the risk of pulling it off,
make sure that the backplate is
mounted straight.

TD 92345GB
Installation Instructions
teleCARE M Pull Cord Switch Module
2005-06-16 / Ver. A Details subject to change without notice

TD 92345GB
Installation Instructions
teleCARE M Pull Cord Switch Module
2005-06-16 / Ver. A Details subject to change without notice
Pull Cord Switch Module Programming
Solder Pad Settings

TD 92345GB
Installation Instructions
teleCARE M Pull Cord Switch Module
2005-06-16 / Ver. A Details subject to change without notice
Positioning of the teleCARE Peripherals

TD 92345GB
Installation Instructions teleCARE M Pull Cord Switch Module 2005-06-16 / Ver. A Details subject to change without notice
teleCARE Switch Module
Dismantling Instructions
To remove the face plate of the teleCARE switch modules
a screwdriver with a point of approximately 6mm wide is
to be used.
Insert the point of the screw-
driver into the groove at the
side of the switch module,
between the face plate and
the backplate (or surface
mounting frame) at about
10mm from one of the top
corners.
Gently push and turn the screw driver until
the faceplate releases from the backplate.