ASCOM TEMS POCKET REMOTE - DATASHEET 2 User manual

PRODUCT SHEET
Product: TEMS™ Automatic – Handheld Test Device
GSM/GPRS/EDGE/WCDMA/HSDA
TEMS™POCKET REMOTE
HANDHELD TEST DEVICE FOR
TEMS™AUTOMATIC
TEMS Pocket Remote collects and uploads net-
work data while working as a normal handset.
This allows TEMS Automatic to truly test network
quality from a subscriber’s perspective.
The TEMS Pocket Remote package expands the measurement capabilities of
the TEMS Automatic solution. Each TEMS Pocket Remote is a terminal-based
test probe used for quality assessment.
This test unit enables operators to monitor areas of the network where
it is difficult for vehicle-based RTUs to obtain measurements. By placing
handheld test probes in the hands of users moving throughout the network,
operators can get a true picture of network quality from a user’s perspective.
This gives operators the ability to troubleshoot and improve the network
and also supports the making and marketing of service level agreements
based on network quality.
TEMS Pocket devices are commercial handsets to which autonomous
network monitoring capabilities have been added. The phone device can be
used as your everyday phone and also do autonomous testing.
Like the traditional test units used with TEMS Automatic, TEMS Pocket
Remote is controlled from a TEMS Automatic back-end server. From the
main console, the operator can send test instructions over the air interface
to groups of devices. Logfiles are created based on these instructions until
they are changed. The test instructions can be changed at any time from
the operator’s console, giving the operator complete control of the type and
frequency of the tests.

PRODUCT SHEET: TEMS POCKET REMOTE
TEMS Pocket Remote performs its measurements automatically, with no
action required by the person using the handset. Testing is invisible; recording
takes place in the background of calls either initiated by the user (passive
testing), or initiated by the test unit (active testing), with a minimum of
impact on the user.
For positioning, the phone device uses an integrated GPS or an external
GPS. If positioning is not available TEMS Automatic will use Cell Id to display
the measurement information.
TEMS Pocket Remote is fully integrated into TEMS Automatic, using
the same interface mechanisms for uploading and downloading data and
presentation of measurement results. The data collected by TEMS Automatic
using TEMS Pocket Remote units can be used for analyzing trends, optimizing
networks, benchmarking competitors, and verifying quality as experienced
by the users.
Radio and network parameter information is presented, along with
end-to-end service testing. The information can be used by different groups
within an operator’s organization to improve the overall service quality.
The handheld devices provide the opportunity to measure quality from
an end-user’s perspective more closely than ever before, while at the same
time providing details necessary for later troubleshooting.
Adding TEMS Pocket Remote probes to the TEMS Automatic solution
increases the system’s capacity to monitor network quality. It opens up new
ways of effortlessly collecting data from anywhere in the network. It is a simple
new way to use TEMS Automatic to test from a user’s perspective. With hand-
held devices for quality monitoring, TEMS Automatic is even more accurate and
cost-effective for operators hoping to maximize network quality.
Ascom Network Testing Inc.
1943 Isaac Newton Square
Reston | VA | 20190-5006 | USA
www.ascom.com/tems 11.2010 © Ascom 2010. All rights reserved. TEMS is a trademark of Ascom. All other trademarks are the property of their respective holders. | DSH-2/8904-0002 Rev A Uen
Feature TEMS Pocket 7.3 Remote TEMS Pocket 10.0 Remote
Mobile phone Sony Ericsson W995/a/EDGE Sony Ericsson Experia X10a/i
Positioning Integrated or external Bluetooth®GPS Integrated GPS
Testing capability, Active Voice, Idle, HTTP, FTP data, E911 testing Voice, Idle, HTTP, FTP data, Ping
Testing capability, Passive Voice, HTTP -
WCDMA band 850/1900/2100 or 900/1900/2100 MHz 800/850/1900/2100 or 900/1700/2100 MHz
GSM/GPRS/EDGE band 850/900/1800/1900 MHz 850/900/1800/1900 MHz
Control capability RAT, (PS) Bearer, Band, Preferred voice codec incl. AMR-WB -
TEMS Pocket Remote specifications