ASROCK iEPF-9000S-EX4 User manual

iEPF-9000S-EX4
iEPF-9002S-EX4
iEP-9000E
iEP-9002E
User Manual
Version 1.0
Published August 2022
Copyright©2022 ASRockInd INC. All rights reserved.

Version 1.0
Published August 2022
Copyright©2022 ASRockInd Inc. All rights reserved.
Copyright Notice:
No part of this documentation may be reproduced, transcribed, transmitted, or
translated in any language, in any form or by any means, except duplication of
documentation by the purchaser for backup purpose, without written consent of
ASRock Rack Inc.
Products and corporate names appearing in this documentation may or may not
be registered trademarks or copyrights of their respective companies, and are used
only for identication or explanation and to the owners’ benet, without intent to
infringe.
Disclaimer:
Specications and information contained in this documentation are furnished
for informational use only and subject to change without notice, and should not
be constructed as a commitment by ASRock Rack. ASRock Rack assumes no
responsibility for any errors or omissions that may appear in this documentation.
With respect to the contents of this documentation, ASRock Rack does not provide
warranty of any kind, either expressed or implied, including but not limited to
the implied warranties or conditions of merchantability or tness for a particular
purpose.
In no event shall ASRock Rack, its directors, ocers, employees, or agents be liable
for any indirect, special, incidental, or consequential damages (including damages
for loss of prots, loss of business, loss of data, interruption of business and the
like), even if ASRock Rack has been advised of the possibility of such damages
arising from any defect or error in the documentation or product.
is device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CALIFORNIA, USA ONLY
e Lithium battery adopted on this motherboard contains Perchlorate, a toxic substance
controlled in Perchlorate Best Management Practices (BMP) regulations passed by the
California Legislature. When you discard the Lithium battery in California, USA, please
follow the related regulations in advance.
“Perchlorate Material-special handling may apply, see www.dtsc.ca.gov/hazardouswaste/
perchlorate”
ASRock Rack’s Website: www.ASRockRack.com

Important Safety Instructions
For user safety, please read and follow all instructions, Warnings, Cautions,
and Notes marked in this manual and on the associated device before handling/
operating the device, to avoid injury or damage.
1. Read these safety instructions carefully.
2. Retain this user manual for future reference.
3. Read the Specications section of this manual for detailed information on the
recommended operating environment.
4. Disconnect the equipment from all AC outlets before cleaning. Use only a damp cloth
for cleaning. Do not use liquid or sprayed detergent.
5. Place the equipment on a reliable surface during installation. Dropping or letting the
equipment fall may cause damage.
6. Do not leave the equipment in an environment with a storage temperature of below
-40 °C (-40 °F) or above 85 °C (185 °F) as this may cause damage. e equipment
should be stored in a controlled environment.
7. Ensure that the voltage of the power source is correct before connecting the equipment
to a power outlet.
8. Position the power cord away from high-trac areas. Do not place anything over the
power cord.
9. If the equipment is not used for a long time, disconnect the equipment from the power
source to avoid damage from transient over-voltage.
10. All cautions and warnings on the equipment should be noted.
11. To avoid electrical shock and/or damage to the device:
• Keep the device away from water or liquid sources.
• Keep the device away from high heat or humidity.
• Keep device properly ventilated (do not block or cover ventilation openings).
• Always use designated voltage and power source settings.
• Always install and operate the device near an easily accessible electrical outlet.
• Secure the power cord (do not place any object on/over the power cord).
• Only install/attach and operate the device on stable surfaces and/or designated
mountings.
• e power cord must be connected to a socket or outlet with a ground connection.
12. If one of the following occurs, have the equipment checked by service personnel:
• e power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• e equipment has been exposed to moisture.
• e equipment is malfunctioning or does not operate according to the user manual.
• e equipment has been dropped and damaged.
• e equipment shows obvious signs of breakage.

13. Never attempt to repair the device, which should only be serviced by qualied technical
personnel using suitable tools.
14. Any unveried component may cause unexpected damage. To ensure correct
installation, always use the components (e.g., screws) provided in the accessory box.
15. is equipment is not suitable for use in locations where children are likely to be
present.
16. e equipment should only be installed in a restricted access area.
17. Restricted Access Location:
e device must be installed only in a server room or computer room where access is:
• Access can only be gained by service persons or by users who have been instructed
about the reasons for the restrictions applied to the location and about any precautions
that shall be taken.
• Access is through the use of a tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location.
• Leave enough clearance (25 inches in the front and 30 inches in the back of the rack) to
allow the front door to be opened completely and to allow for sucient airow.
• is product is for installation merely in a Restricted Access Location.
• is product is not suitable for use with visual display workplace devices according to §2
of "the German Ordinance for Work with Visual Display Units".
18. e equipment is intended to be supplied by the external power source (UL listed/ IEC
60950-1/ IEC 62368-1 approved) whose output complies with ES1/SELV. To reduce
potential safety issues, only the AC adapter provided with the product, a replacement
AC adapter provided by ASRock Industrial or agency, or an AC adapter purchased as
an accessory from ASRock Industrial or agency should be used with the product.
19. is power adapter (FSP330-AAAN3) is intended to be supplied based on a UL-
certied and suitable for use at an operating/storage temperature of 0 °C (32 °F)~ 40 °C
(104 °F)/ -20 °C (-4 °F)~80 °C (176 °F), and the current output is rated 13.75A. If you
need further assistance, contact ASRock Industrial for additional information.
20. e ambient temperature of the iEP-9000E series: 70 °C (158°F) max.; the ambient
temperature of the iEPF-9000S series: 75 °C (167°F) max.
21. e terminal block is suitable for V+& V-, 3 units for each (16~18AWG) which means
6 units in total. e torque value is 0.69Nm. And use copper conductors only. Kindly
note that must be installed by a skilled person.
22. LAN port must use shielded LAN cable.

Replaceable Batteries
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
CAUTION
e equipment is equipped with a battery-powered real-time clock circuit. ere is a risk
of explosion if a battery is incorrectly replaced. Replace only with the same or equivalent
type as designated by the manufacturer. Discard all used batteries according to the
manufacturer's instructions.
LITHIUM-METAL BATTERY WARNING
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type designated by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
WARNING
All interconnection to the EUT is for indoor location and therefore PoE network
interconnected to the EUT is considered as ES1/SELV for connected only to PoE network
without routing to the outside plant.
WARNING
Input voltage rated 9~36V, 30~18A
Packing: e unit should be carried with both hands and handled with care.
Maintenance: Use only approved products or a dry applicator to clean and maintain the
surfaces.
e terms HDMI™ and HDMI High-Denition Multimedia Interface, and the HDMI
logo are trademarks or registered trademarks of HDMI Licensing LLC in the United
States and other countries.

Contact Information
If you need to contact ASRock Industrial or want to know more about ASRock Industrial,
you’re welcome to visit ASRock Industrial’s website at www.asrockind.com ; or you may
contact your dealer for further information.
ASRock Industrial Incorporation
Email: [email protected]
.

Contents
Chapter 1 Introduction 1
1.1 Key Features 1
1.2 Package List 3
1.3 Specications 5
1.4 Dimensions 13
1.5 Block Diagram 21
Chapter 2 System Overview 25
2.1 System Front Panel 25
2.1.1 Control Panel Buttons and LED Indicators 27
2.1.2 I/O Connectors 29
2.2 HDD Panel 30
2.3 Drive Tray LEDs 31
Chapter 3 Hardware Installation and Maintenance 32
3.1 How to Install the Hard Disk Drive 33
3.2 How to Install the SIM Card 35
3.3 How to Disassemble the System 37
3.4 How to Install the Desk Mount Bracket 42
3.5 How to Install the Rubber Foot 43
Chapter 4 Motherboard 44
4.1 Motherboard Layout 44
Chapter 5 UEFI Setup Utility 51
5.1 Introduction 51
5.2 Main Screen 52

5.3 Advanced Screen 53
5.3.1 CPU Conguration 54
5.3.2 Chipset Conguration 56
5.3.3 Storage Conguration 58
5.3.4 Super IO Conguration 59
5.3.5 ACPI Conguration 61
5.3.6 USB Conguration 62
5.3.7 Trusted Computing 63
5.4 Hardware Health Event Monitoring Screen 65
5.5 Security Screen 66
5.6 Boot Screen 67
5.7 Exit Screen 68

iEPF-9000S-EX4 / iEPF-9002S-EX4 /
iEP-9000E / iEP-9002E
PB 1
English
Chapter 1 Introduction
ank you for purchasing iEPF-9000S-EX4 / iEPF-9002S-EX4 / iEP-9000E / iEP-9002E,
a reliable barebone system produced under ASRock Industrial’s consistently stringent
quality control. It delivers excellent performance with robust design conforming to
ASRock Industrial’s commitment to quality and endurance.
1.1 Key Features
iEPF-9000S-EX4
• Intel® 10th Gen Xeon® W or Core™ Processors with W480E Chipset
• 4 x 260-pin DDR4 SO-DIMM up to 128GB (32GB per DIMM)
• 1 x PCIe x16 (PCIe Gen3) or 2 x PCIe x8 (PCIe Gen3), 2 x PCIe x4 (PCIe Gen3)
• 1 x M.2 Key M, 1 x M.2 Key B, 1 x M.2 Key E, 2 x Mini PCIe
• 4 x USB 3.2 Gen2x1, 2 x USB 2.0, 6 x COM, 4 x SATA3, 8 x DI, 8 x DO
• 5 x Intel Gigabit LAN (2 support PoE)
• Supports Triple Display, 2 x Displayport, 1 x VGA
• Powerful Edge AI acceleration enabled by the most exible mechanical, thermal, and
power design, with support for 275mm x 111.15 mm (L x H) max. and up to 255W
graphics card
iEPF-9002S-EX4
• Intel®10th Gen Core™ Processors with H420E chipset
• 2 x 260-pin DDR4 SO-DIMM up to 64GB (32GB per DIMM)
• 1 x PCIe x16 (PCIe Gen3), 1 x M.2 Key M, 1 x M.2 Key B, 1 x M.2 Key E,
• 2 x Mini PCIe
• 4 x USB 3.2 Gen1x1, 2 x USB 2.0, 6 x COM, 2 x SATA3, 8 x DI, 8 x DO
• 3 x Intel Gigabit LAN
• Powerful Edge AI acceleration enabled by the most exible mechanical, thermal, and
power design, with support for 275mm x 111.15 mm (L x H) max. and up to 255W
graphics card
Because the hardware specications might be updated, the content of this documentation
will be subject to change without notice. In case any modications of this documentation
occur, the updated version will be available on ASRock Industrial’s website without further
notice. If you require technical support related to this product, please visit our website for
specic information about the model you are using.
ASRock Industrial’s Website: www.ASRockInd.com
e illustrations shown in this manual are examples only. e actual system may dier
depending on the product model you purchsed.

2 3
English
iEP-9000E
• Intel® 10th Gen Xeon® W or Core™ Processors with W480E Chipset
• 4 x 260-pin DDR4 SO-DIMM up to 128GB (32GB per DIMM)
• 1 x M.2 Key M, 1 x M.2 Key B, 1 x M.2 Key E, 2 x Mini PCIe
• 4 x USB 3.2 Gen2x1, 2 x USB 2.0, 6 x COM, 4 x SATA3, 8 x DI, 8 x DO
• 5 x Intel Gigabit LAN (2 support PoE)
• Supports Triple Display, 2 x Displayport, 1 x VGA
iEP-9002E
• Intel®10th Gen Core™ Processors with H420E chipset
• 2 x 260-pin DDR4 SO-DIMM up to 64GB (32GB per DIMM)
• 1 x M.2 Key M, 1 x M.2 Key B, 1 x M.2 Key E, 2 x Mini PCIe
• 4 x USB 3.2 Gen1x1, 2 x USB 2.0, 6 x C OM, 2 x SA TA3, 8 x DI, 8 x DO
• 3 x Intel Gigabit LAN