Astonica 50103301 User manual

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT OVERSTOCK.COM CUSTOMER SERVICE AT
1-800-843-2446
180106rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
CONTACT CONSUMER SUPPORT AT
1-800-843-2446
Warranty Information:
Products for Home Use
This item and or product is not covered under original manufacturer's warranty.
For warranty issues please contact the retailer directly at
1-800-843-2446
or
www.Overstock.com
Made in China
Distributed by:
Overstock.com
6350 South 3000 East
Salt Lake City, UT 84121
OV SKU No. 10085137-000-000
Model No. 50103301
Cast Aluminum Round Table
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-800-843-2446.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not over tighten threaded studs, aluminum is a soft metal
 and threads can easily be stripped.
1. (SEE FIGURE 1) Place table top (A) upside down on a flat, non-scratching surface.
2. Locate threaded holes under table top (A), and install threaded studs (eight places).
3. Install threaded studs (E) from under table top into table legs (B). Repeat with other
 three table legs (B).
4. Place table leg (B) upside down, and mount legs to table using mounting hardware,
 flat washers (G), lock washers (H) and nuts (F).
5. Align support ring (C) and one table leg (B). Ensure ring tabs on support ring are facing
 upward. Join table and support ring using flat washers (G), lock washers (H) and hex nuts (F).
 Hand tighten only to hold it in place. Repeat with other three table legs.
6. Stand the table upright and securely tighten hardware in an “X” pattern.
7. Fix the adjustable feet (D) under table legs (B). Adjust feet until table stands level.
A
B
C
D
F
ASSEMBLY INSTRUCTIONS
Figure 1
E
PARTS AND HARDWARE LIST
G
H
Table Top
Leg
Support Ring
Threaded Stud, 8mm
Lock Washer, 8mm
Hex Nut, 8mm
Flat Washer, 8mm
1
4
1
16
Adjustable Foot 4
16
16
16
AB
GF
DE
H
A
E
G
H
F
C
D
DESCRIPTION
PART # QUANTITY
G
H
F
C
B
Parts Detail
12