Atmos C 341 User manual

Quick Guide ATMOS®C 341 Battery
This Quick Guide does not replace the operating instructions.
For your safety
• Recharge the battery at the latest after 3 months, even if you do
not use the device.
• Perform a function check after each use. Perform a function
check every 4 weeks in case you do not use the device for a
longer period.
• The device may only be used by persons who were medically
trained, and were trained in the medical suction.
• Donotoperatethedevicewithoutabacteriallter.
Device overview
1
2
3
4
5
6
71011
12 9
8
1Control panel
2Battery compartment cover
3Device base
4Release button wall and
device support
5Hose rewind with suction
hose
6Connection charging
accessories
7Guide for the wall and device
support
8Display of battery status
9Vacuum controller
10 Vacuum display
11On/obutton
12 Power indicator
Display of the battery status
• The following display values are not valid during battery charging.
• The battery status must be supervised visually.
• If only the red LED lights up, although the battery has been loaded
for a longer period, the battery is defective.
≤100% ca.70% ca.40% <10%
Support
Mounting Removal

Switching on and operate
Switching on Vacuum adjustment Switching o
1. Presstheon/obutton.
»The pump starts.
»TheLEDabovetheon/o
button is illuminated as long
as the device is switched on.
2. Turn the vacuum controller
for adjusting the required
vacuum.
»The vacuum display
shows the current suction
performance.
3. Presstheon/obuttonforatleast1second.
4. Clean and disinfect the device after every use.
5. Perform a function check after each cleaning and disinfection.
Cleaning and disinfection Function check
What How When
Parts to be reprocessed
C D S
Daily* Every14days* After each patient / after each suction Cleaning Disin- fection Sterili- zation
Surfaces
Housing X X X X
Device base X X1X X
Hose rewind X X1X X
Wall and device support X X X
Power supply and
recharging unit X X X
Canister system
DDS secretion canister X X1X2X X
Outer canister lid (DDS) X X1X2XX
Inner canister lid (DDS) X X1X2X X
Float ball (DDS) X X1X2X X
Filter holder X X1X2X X
Sealing ring X X1X X
Bacteriallter X X
Fingertip X X
Support for canister system X X1X X
Suction hose (DDS)
X X1X2X X
X X1X2X X
1)Preferred:machinecleaninganddisinfectioninthewasherdisinfector(rinsecycleupto
95°C)
2)Ifrequiredhot-steamsterilizationat134°Cwithdevicesacc.toEN285
Manual
1. Please check whether the following parts are damaged or
torn:
- all hoses
- Canister system
2. Switch on the device.
3. Check:LEDsandbatterystatus.
4. Connectangertiptothesuctionhoseandclosethe
auxiliary air vent.
5. Closethefrontopeningofthengertipwithyourthumb.
6. Selectthevacuum-0.5bar.
7. Please check whether the device reaches the vacuum after
approx.20seconds:Thepumpswitchesoandthevacuum
displayshows-0.5bar.
8. Incasethedevicedoesnotreachthevacuumwithin20
seconds:Checkthedeviceonpotentialsourcesoferror.
GA2GB.320101.02017-03Index:01