AUTOCUE iPad Lite User manual

5. Centre the lens in the
aperture at the rear of
the hood, by raising or
lowering the hood.
Secure it in place by
tightening the two thumb
screws. (B)
iPad Lite
Guide
Mounting the Camera
It is important that the camera lens is in the centre of
the aperture at the rear of the hood. This is achieved by
raising and lowering the hood and fitting a camera
riser.
Fix the camera in place
using the camera screw
provided.
1/4” BSW
Camera Screw
Camera Riser
2. Install camera riser to
the camera mounting
plate using the camera
screw provided
3. Raise the camera to
the vertical position.
Secure by tightening
the four thumb screws.
4. Slide the camera
forward so that the lens
is in the aperture at the
rear of the hood.
1. Fit camera riser to
the camera. autocue.com
(B)

Assembly
1. Fix the hot shoe
from your tripod to the
underside of the
mounting plate. Slide
the hot shoe to the
approximate position
and tighten the
screws.
Components A Hood and
Glass
B iPad
C Mounting
Plate
D
Hood
Adjustment
Screws
D
C
A
B
2. Mount the unit
on the tripod. 6. Raise the hood up into
the vertical position.
7. Lock the hood into
position by tightening
the two thumb
screws. (B)
4. Place the iPad so that
the front edge is under
the retainer (C)
If you have an iPad 2
please use the adaptor
kit provided.
5. To secure the iPad
in place slide the
retainer forward so
that the corners of
the iPad are located
in the mount. (D)
3. To mount the iPad
loosen the thumb
screws (B) and slide
the carrier to the
open position.
Use two fixing if possible.
(B)
(B)
(C)
(D)
Vercal posion