AUTOCUE SSPi User manual

Guide
Straight-read Assembly
SSPi
iPhone Prompter
1. Place your SSPi on a smooth, level
surface. Remove the thumbscrews holding
the hood and iPhone mounng plate.
2. Remove the two thumbscrews
attaching the iPhone mounting
bracket to the drop bracket.
3. Remove the knob securing the
iPhone carrier to the iPhone
carrier mounting bracket.
4. Align the bolt on the back of the
iPhone carrier with the hole in the
centre of the drop bracket.
5. Secure it to the drop plate
with the knob.
6. Attach an optional pistol
grip to the hot shoe plate on
the underside of the SSPi unit.
7. Now attach your camera
to the camera mounting
bracket using the screw
supplied.
Camera screw
Mount the camera to the camera mounting bracket
using the 1/4” BSW camera screw, slide the camera
forward and ensure that the lens is inside the hood.
Use the hood slide screw to centre the lens inside
the hood and place the black light excluder around
the lens. Secure it using the drawstring.
Mounting the Camera
Camera Balancing
Loosen the two screws
(marked A in the picture) so
that the hot shoe plate will
slide back and forth.
A
A
Mount the unit with
camera attached to the
tripod and slide the unit
back and forth until you
achieve a balance.
Then retighten the
screws.
autocue.com

Assembly
A
B
C
D
E
G
F
1. Remove the unit from its case
and carefully place the glass
side face down, onto a level
surface.
2. Loosen the thumbscrews holding the iPhone
carrier mounting plate and raise the iPhone carrier.
3. Align the metal tongue of the iPhone carrier
plate with the slot in the drop bracket and carefully
insert the tongue into the slot. (fig. i)
4. Tighten the thumbscrews to secure the iPhone
carrier mounting plate. (fig. ii)
5. Attach the tripod camera mounting plate
to the hot shoe plate on the underside of
the SSPi unit.
6. Slide the on-camera
unit onto your tripod.
7. Loosen the two thumbscrews
holding the iPhone carrier mounting
plate and hood assembly.
8. Raise the hood assembly to
the vercal posion and ghten
the thumbscrews.
9. Rotate the camera bracket so that it is on the
top of the unit and behind the hood.
Components
10. Fix your camera to the bracket using the
camera screw. Slot the bracket over the
thumbscrews and tighten all four thumbscrews to
secure it.
11. Fit your iPhone into the iPhone carrier by
loosening the knob on the underside. Slide the
two components apart, then close ensuring the
corners of the iPhone are held securely by the
carrier.
AHood and glass
BiPhone carrier
CHood Bracket
DCamera Bracket
EHot Shoe Plate
FDrop Bracket
GCarrier
mounting plate
HHood
thumbscrew
I Hood Slide
Screw
g. i g. ii
HVertical position
I