Autonomous ErgoChair User guide

OVERALL SIZE
UNIT: mm
PART LIST
650
450
1170 -1290
470-520
670 -795
670
480
735
A B
EFGH
Q
Right Left
C D I x 4 (M8 x 25mm)
J x 3 (M6 x 22mm)
K x 7 (M6 x 35mm)
P x 8 (M8)
O x 8 (Ø 8 x 17 x 1.5mm)
N x 7(Ø 6 x 14 x 1.5mm)
L x 5 (M8 x 55mm)
M x 1

H
Q
E
D
F
Step 1 Step 2
Step 3 Step 4
K
G
C
N
Put Part Q into the Mechanism
(H).

Push the handle and the
mechanism to the end following
the arrow direction at the same
time, so the screw holes appear.
L P O
Keep the holes in the metal bar in
line with the plywood before
assembling the back, then tighten
the screws that are diagonal to
each other halfway.
Step 5 Step 6
Step 7 Step 8
I
A
P O
L P O
Tighten another two screws in the
metal bar.

B
J
Step 9 Step 10
Operation Guide
Lift up the
handle to
adjust the
seat tilt.
Rotate the
handle to adjust
the strength of
back tilt
tension

This handle
controls angle
of the back of
the chair.
Pull the
handle up
to adjust the
seat height.
A is locked position
B is unlocked position.
60mm front and back
Pushing the handle up allows the seat
cushion to move forward up to 60mm.
Release the handle and the seat is
locked.

45 degrees adjustment
70mm up and down 30mm left
and right
40mm front and back
70mm up and down

WARNING
Failure to follow these instructions may result in serious injury.
1. This product is designed for seating only, do not stand on
this product. Do not use it as a step ladder.
2. Do not use this product unless all bolts and parts are rmly
tightened.
3. If any parts are missing, damaged or worn, stop using this
product. Repair the product with the replacement parts from
manufacturer.
4. Do not sit on the armest of this product.
5. This product is designed for one person sitting at a time.
6. Keep out of reach of children under the age of 10 unless
assistance from an adult is provided.

325 W 38th St, Floor 14, New York, NY 10018
www.autonomous.ai
[e-mail]
v1.1