Avery Dennison 9417 User manual

Avery Dennison® is a registered trademark of Avery Dennison Corporation. ©2013 Avery Dennison Corp. All Rights Reserved.
TC9417PHI Rev. AB6/15
REPLACING THE PRINTHEAD
Use these instructions to replace the printhead assembly in the 9417 Printer.
Audience
These instructions are intended for a skilled service
technician only. For additional information or
assistance, call Service at 1-800-543-6650.
Cautions
♦The 9417 printer contains devices that are
sensitive to electrostatic discharge (ESD); failure
to exercise caution can damage the printer. We
recommend using an ESD wrist strap, grounding
mat, or grounding workbench when performing
maintenance on the printer.
♦Flex connectors between components and board
assemblies are extremely fragile; when damaged,
they require component or board assembly
replacement.
Required Tools
The procedures require the following:
♦A hard, dry surface to set the printer on
♦Phillips screwdriver
Removing the Printhead
1. Turn off the printer and unplug it from the electrical outlet.
2. Open the front cover.
3. Remove the supplies.
4. Remove the six screws that attach the print module covers.
5. Lift up the right then left printer cover; rest them out of the way.

2Replacing the Printhead
6. Lift out the printhead assembly.
7. Open the four black flex connector latches. Remove the flex from the flex connector
Note: Apply careful, even pressure on the latches when opening and closing.
Installing the Printhead
1. Make sure the four black flex connector latches are open, then insert the printhead flex into the
flex connector. Make sure the flex is inserted all the way into the connector.
2. Close all four of the black flex connector latches.
Note: Apply careful, even pressure on the latches when opening and closing.
3. Lay the printhead assembly into place.
Flex Connector Latch

Replacing the Printhead 3
4. Lay the left print module cover in place then lay the right print module cover in place.
5. Secure the printer covers in place.