Avery Dennison Monarch ADTP1 User manual

TC9820PHI Rev. AE1/21©2001 Avery Dennison Corp. All rights reserved.
PRINTHEAD
INSTRUCTIONS
The printhead is sensitive to static electricity, which
can damage the printhead or reduce its life. Ground
yourself by touching metal, such as the printer's metal
base, before touching the printhead.
IMPORTANT
If your Avery Dennison® ADTP1/ADTP2 printer uses a
203dpi printhead, you must update the firmware and
set the Printhead Type.
Update your printer firmware to Version 3.11 or greater.
If you cannot update your firmware, adjust Print
Contrast to achieve optimal print quality or call
Technical Support.
Data streams may override settings made on the
printer.
Compare your new printhead with this photo:
Type R has all metal construction and attaches
with two screws; Type K has black plastic
construction and attaches with one screw.

2
Setting the Printhead Type
To set the Printhead Type:
1. From the Main Menu select TLABEL.
2. Press . You see Printhead Type.
3. Press SELECT.
4. Press or until you see the Printhead Type you
need (Type R or Type K), then press SET.
5. Press BACK until you see “Ready,” then press
SELECT.
Replacing the Printhead
To replace the printhead:
1. Turn off the printer.
2. Open the cover.
3. Unlock the printhead by turning the retaining latch.
4. Press forward and down on the two latches on top
of the printhead assembly as shown. The printhead
will drop out.
5. Lift the printhead assembly using the printhead tab
and push back until the printhead assembly clicks
into place.

3
6. Carefully unplug the cable from the printhead as
shown. The printhead is sensitive to static
electricity, which can damage the printhead or
reduce its life. Ground yourself by touching some
metal, such as the printer's metal base, before
touching the printhead.
7. Carefully plug the cable into the new printhead.
8. Align the new printhead with the tabs.

4
9. Snap the printhead into place.
Make sure the printhead cable does not touch
the ribbon roll.
10. Clean the new printhead with a cotton swab dipped
in isopropyl alcohol to remove any salt or oil left
from handling.
11. Let the printhead dry and reload your supplies.
12. Push down on the printhead assembly to lock it in
place.
13. Close the cover.
14. Turn on the printer and press Feed/Cut to position
the supply.
Do not
touch here