Avery Dennison Monarch SIERRA SPORT4 9493 User manual

TC9460ACPHOI Rev AF 10/07 ©2007 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp.
All Rights Reserved.
ACCESSORY INSTRUCTIONS
These instructions describe how to use the following
options for carrying the Monarch® Sierra Sport2™ 9460™
and Sierra Sport4™ 9493™ portable printers:
♦ hip strap
♦ clip
♦ shoulder strap
♦ hand strap
Information in this document supercedes information in
previous versions. Check our Web site
(www.monarch.com) for the latest documentation and
release information.
Attaching the Hip Strap and Clip
1. Put the hip strap on like a normal belt, inserting one
side of the buckle into the other. The adjustment
slide must face out.
To loosen or tighten the hip strap, move the slide
toward or away from the buckle.
Adjustment Slide

2
2. Press the end of the clip and slide it all the way over
the hip strap or onto a piece of clothing. The slot on
the clip must face out.
3. Lower the printer and slide the strap button into the
slot on the outside of the clip until you feel it click
into place.
Clip
Slot
Strap Button
9460 Printer

3
Pull this side out
Release Tabs
Press release switch
Removing the Hip Strap and Clip
1. Holding the printer with one hand, press the release
switch with your other hand and lift the printer up
and out of the clip.
2. To remove the hip strap, press the end of the
release tabs and pull the other side of the buckle
out.
3. Press the end of the clip and pull it away from the
hip strap or the piece of clothing that you attached it
to.

4
Attaching the Shoulder and Hand Straps
1. On both sides of the printer, place the loop over the
strap button, and pull up gently. You will feel it click
into place.
2. To raise or lower the shoulder strap, move the
adjustment slide toward or away from the end of the
strap.
Removing the Shoulder Strap
On both sides of the printer, gently push down on the
loop attached to the button and pull it away from the
printer.
Adjustment
Piece
Loop and
strap button.