Avery Dennison Monarch 9419 User manual

Avery Dennison® and Monarch® are registered trademarks of Avery Dennison Corporation.
TC9419WFIG Rev. AA 9/16 ©2016 Avery Dennison Corp. All Rights Reserved.
9419 WIFIMODULE INSTALLATION GUIDE
Use these instructions to install the WiFi module on the Avery Dennison® Monarch® 9419 Printer.
Use the Printer Management Utility to configure the WiFi settings. For information, refer to the
Offline/Online System Administrator’s Guide.
You need a small Phillips screwdriver to install the WiFi module.
Caution: Electrostatic discharge can damage or destroy the printhead or electronic components.
1. Turn the cover latches and lift the cover.
2. Remove the WiFi module cover.
3. Insert the WiFi module in the slot.
Note: The wireless module has a
flat corner to match the
opening in the printer; the
module must be inserted as
shown.

2
4. Press the WiFi module until it snaps into place.
5. Replace the WiFi module cover.