AVS Bugflector User manual

Page 1 of 2
Installation Instructions
Important Safety Information
• CAUTION - Before driving, ensure that the hood shield is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
For proper installation and best possible fit, please read all instructions BEFORE you begin.
NOTE: Actual product may vary from illustration.
Bump On
x4Hood shield
Tools Required
Contents
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
Clean Towel
Car Wash Supplies
Installation Steps NOTE: Actual application may vary slightly from illustrations.
Phillips
screwdriver
I - Sheet Number BF119
Bugector® - Bugector II® - Carector® - Chrome Hood Shield™
Grease Pencil
Raise hood and clean the leading edge thoroughly,
and allow to dry.
Screw
x 6
Receptacle
x 6
Test fit hood shield by centering it on the hood edge.
Note where the mounting holes in the hood shield flange
will be and mark with a grease pencil.
12

NOTE: Actual application may vary slightly from illustrations.
Installation Steps
Page 2 of 2
Lower hood, adjust hood bumper stops to ensure
hood shield clears grille and headlights. Install bump
ons at pre-cleaned locations on the painted hood/
fender surface.
Position the hood shield with the flanges sliding between the hood
and rubber seal. Align holes.
Insert (6) receptacles UNDER rubber trim and through
hood shield, and then into hood.
Insert (6) screws through rubber trim and into recep-
tacles and apply pressure while tightening screw to
secure to hood.
Remove the corresponding fasteners from the rubber trim piece. This is necesary in order for the hood shield flanges to slide under the
rubber trim piece. NOTE: It may be necessary to remove additional fasteners in order to accomodate the flange, depending on size.
fastener
receptacle
rubber trim
rubber trim
hood shield
front edge of
hood
hood
rubber
trim
hood shield
receptacle
screw
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top
quality in terms of fit, durability, finish and ease of installation.
4
6 7
5
3
Discover various stone and bug deflectors in our online store.