AXIOMTEK PICO512 Series User manual

4 9418H512000E
© Copyright 2017 Axiomtek Co., Ltd.
Ver ion A1 March 2017
Printed in Taiwan
Quick Start
CN14 on PICO512
Note: When powering on PICO512 for the first time, video device must be
plugged into HDMI port (CN15). Then, after first power on, you can set
VGA on AX93A00 or HDMI on AX93A01 as primary IGFX boot display
from BIOS setting.
The basic procedures required to power on PICO512:
(1). Require at least 60W DC power adapter. Make sure that all
necessary peripheral devices are plugged properly.
(2). Check all jumper and switch settings and make sure they are
at default settings; especially SW1 (2-3 close).
(3). To ensure normal functioning, DDR4 memory module must be
installed into connector SCN2 until fully seated.
(4). Attach thermal solution as indicated in image below.
(5). Firmly insert the DC adapter into CN14 and power on
PICO512 by inserting power plug.
PICO512 Series Quick Installation Guide
9418H512000E 1
© Copyright 2017 Axiomtek Co., Ltd.
Ver ion A1 March 2017
Printed in Taiwan
Checklist

CPU
Board x1

Product Information
C
D
x1

USB Cable x1

Quick Installation Guide
x1

SATA
Cable x1

Heatspreader x1

SATA Power Cable x1

Heatsink w/Fan x1

Fan C
a
ble x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Please refer to the PICO512 series product information CD for the
complete user’s manual, drivers and utilities. User’s manual and related
documents are in Acrobat PDF format.
Connectors
Connector Description
CN2 Board to Board Connector 1 (Low Speed)
CN3
Board to Board Connector 2
(
High Speed
)
CN4
SATA Connector
CN5
CMOS Battery Connector
CN6 Fan Power Connector
CN7
Digital I/O
Connector
CN8
SATA Power C
onnector
CN9
Front Panel Connector
CN10
USB 2.0 Wafer Connector
CN11
Inverter Connector
CN12 (Optional)
Power Wafer Connector
CN13 Ethernet Port
CN14
DC Jack Power Connector w/ Screw
CN15
HD
MI
Connector
CN16
LVDS Connector
CN17
I2C Connector
SCN1 Full-size PCI-Express Mini Card and mSATA
Connector
S
CN2
DDR
4
SO
-
DIMM Connector
PICO512 7
th
Generation Intel
®
Core
TM
i7/ i5/ i3 and Celeron
®
Processors Pico ITX Board

2 9418H512000E
© Copyright 2017 Axiomtek Co., Ltd.
Ver ion A1 March 2017
Printed in Taiwan
Jumper and Switch Settings
Before applying power to the PICO512, please make sure all of the jumpers
and switch are in factory default positions.
Jumper and Switch Description Setting
JP1 Restore BIOS Optimal Defaults
Default: Normal Operation 1-2 Close
JP2 LVDS Voltage Selection
Default: +3.3V Level 1-2 Close
SW1 Auto Power On
Default: Enable 2-3 Close
Board Layout
Top View
Side View
9418H512000E 3
© Copyright 2017 Axiomtek Co., Ltd.
Ver ion A1 March 2017
Printed in Taiwan
Bottom View
Side View