AXIOMTEK UST500-517-FL Series User manual

94174500000E
©Copyright 2018 Axiomtek Co., Ltd.
Versio A1 Aug. 2018
Pri ted i Taiwa
4
Step 2 Loosen all screws and open the cover carefully.
Step 3 Install mPCIe cards and secure the cover back to original Fasten position to complete the
mPCIe card installation.
Step 4 Fasten all screws tight and slide the secured SATA drive back to complete the installation.
Note: NO.2 half mini card slot can use SW 2 select mSATA or PCIe function. (Default mSATA mode)
UST500-517-FL Quick Installation Guide
94174500000E
©Copyright 2018 Axiomtek Co., Ltd.
Versio A1 Aug. 2018
Pri ted i Taiwa
1
Packing List
System Unit x 1 CD x 1 (for Window10 x64 Driver)
Quick Installation Guide x 1 CPU Grease x1
HDD screw x 16 Terminal Block x1
Audio Cable Fixed x1 Wall mount kit x1
HDMI Cable Fixed x1 Wall mount kit screw x4
Cable tie x3 DIO Connector x1
Cable Fixed screw x3 Cable tie x3 Mini Card Slot screw x8
Footpad x4
 DO NOT apply power to the board if there is any damaged component.
Power On
1. Power Connector:
+: DC power in V+
- : DC power in V-
ACC : Accessory Power In
2. Quick Power On Function:
Power On: ACC connects to V+.
Installation of Hard Disk Drive
Step 1 Turn off the system and unplug the power adaptor.
Step 2 Extract the SATA drive. Each drive can install 2 storages.
UST500-517-FL Series Embedded System

94174500000E
©Copyright 2018 Axiomtek Co., Ltd.
Versio A1 Aug. 2018
Pri ted i Taiwa
2
Step 3 Turn the SATA drive upside down to install storage 2 and insert 8 screws to secure the SATA
drive.
Please notice the direction of connector for HDD.
Step 4 Slide the secured SATA drive back to complete the installation.
Installation of SO-DIMM Memory
Step 1 Turn off the system and unplug the power adaptor.
Step 2 Loosen all screws of the heatsink and remove the heatsink from the system.
Step 3 Located the dual SO-DIMM sockets on main board.
Note: Please install the CPU first and use thermal grease evenly on the CPU top face.
94174500000E
© Copyright 2018 Axiomtek Co., Ltd.
Versio A1 Aug. 2018
Pri ted i Taiwa
3
Step 4 Locate the memory module, insert a gold-colored contact into the socket and push the module
two end latches till locked.
Step 5 Make sure all thermal pads are in the correct position.
Step 6 Put the heatsink back to the system, and fasten screws tight close the chassis.
Note: Please refer to the user’s manual to get more detail information.
Installation of mPCIe card
Step 1 Turn off the system and turn it upside down as below shown. Extract the SATA drive as shown.