
INSTRUCTIONS FOR A CORRECT USE
MEASUREMENT OF THE FOREHEAD TEMPERATURE (HEAD)
1) Make sure that the probe is clean and integral.
2) Clean the temple where the probe will lean.
3) Switch on the thermometer, by pressing the key “ON/MEM”.
On the display appear all the function symbols (self-test); after
few seconds, the display shows the message “HEAD-C°” and
emits two beeps. At this point, the thermometer is ready for
Lean the probe on the right or left temple;
Lean the probe on the right or left temple;
SCAN and keep it pressed, then slowly move the probe around
The thermometer emits beeps indicating that the measurement
5) A longer and more intense acoustic signal indicates that
the measurement has ended (Time necessary to perform the
measurement ranges from 5 to 30 second according to the
temperature of the person).
Should the temperature exceed 37.5°C, the thermometer emits
a long beep followed by other three shorter beeps.
6) Release the key SCAN and then detach the probe from the
temple; read the measured value on the display
the temperature shown on the display is equal to the oral
temperature, i.e. temperature measured on the forehead is
translated as if it were measured in the mouth.
7) The device switches off automatically after 1 minute, if it is
MEASUREMENT OF THE ROOM TEMPERATURE (
This thermometer allows the measurement of the room temperature.
1) Switch on the thermometer, by pressing the key “ON/MEM”.
On the display appear all the function symbols (self-test); after
few seconds, the display shows the message “HEAD-C°” and
2) Keep the key “ON/MEM” pressed and then press the key SCAN.
EnglishINFRARED FOREHEAD THERMOMETER
MEASUREMENT OF THE ROOM TEMPERATURE (
All manuals and user guides at all-guides.com