BaByliss BIG HAIR CARE AIRSTYLER User manual

BIG HAIR CARE AIRSTYLER
2950U
SAFETY CAUTIONS
• This appliance should only be used as described within
this instruction booklet. Please retain for reference.
IMPORTANT CHILD SAFETY
WARNING! Polythene bags over a product or package
may be dangerous. To avoid danger of suffocation, keep
this wrapper away from babies and children. This bag is
not a toy.
WARNING! THIS APPLIANCE GETS HOT!
• ALWAYS keep out of reach of children (during and after
use and whilst cooling).
• This appliance should not be used, cleaned or
maintained by children.
• Always take extra care if used on children or near
children.
• Do not use on very young children.

IMPORTANT SAFETY
• UK Only: This appliance must not be used in
the bathroom.
• Outside the UK: If using the appliance in a bathroom,
unplug after use as the proximity of water can be
dangerous even if the appliance is switched off. For
additional protection the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
• WARNING! Do not use this appliance near water
contained in basins, bathtubs or other vessels.
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
discontinue use immediately. Contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’
section for further information).
• Do not use the appliance if the lead is damaged. In
the event of damage, discontinue use immediately.
If the lead is damaged it must be replaced by the
manufacturer. Return the appliance to the Customer
Care Centre (refer to ‘UK After Sales Service’ section
for further information). No repair must be attempted
by the consumer.
• Do not leave the appliance unattended when switched
on or plugged in.

• This unit is equipped with a safety thermostat. In the
event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the airstyler to the “0” position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear lter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug, and contact the Conair Customer Care Line
(refer to ‘UK After Sales Service’ section for further
information).
• Do not place the appliance on any heat sensitive
surface whilst in operation.
• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.
• Always ensure that the rear air lter is kept away from
hair during use to prevent it being dragged into the fan
which may cause the appliance to overheat.
• Take care using this appliance when wearing
jewellery, in particular necklaces and earrings to avoid
entanglement in the rotating brush head.
• This appliance should not be used by adults whose
reduced physical, sensory or mental capabilities, or
whose lack of experience and knowledge, might cause
a hazard, unless they have been correctly instructed to
understand the safe use and hazards involved and are
adequately supervised.

• After use, do not coil the lead around the appliance as
this may cause damage to the lead. Instead, coil the
lead loosely by the side of the appliance.
• This product complies fully with all appropriate EU
and UK Legislation and the Standards relevant to this
type and class of appliance. We are an ISO9001:2015
certied company that continually evaluates our
Quality Management System performance. If you have
any queries regarding product safety and compliance,
please contact our Customer Services Department.
(See “U.K. After Sales Service” section for further
information.)
INSTRUCTIONS FOR USE
• Ensure the hair is 80% dry and combed through to remove any
tangles. Divide the hair into sections.
• To turn the appliance on, slide the switch to the heat setting suitable
for the hair type.
• Place the brush underneath the hair section close to the scalp and
hold for a few seconds to boost volume at the roots.
• Use the brush to lift the hair at the roots as you dry.
• Move the appliance down through the hair and start to rotate the
brush away from your head by pressing and holding the appropriate
rotation button.
• As you do this, resist the rotation of the brush by pulling the brush
downwards. This will create tension through the section of hair.
IMPORTANT! It may take several attempts to perfect this technique,
if the brush spins too quickly, simply release the rotation button and
remove from the hair.
• As you reach the ends of the hair section, continue rotating the brush
to roll the ends under.

• For even more volume, place the brush at the end of the hair section
and allow the brush to rotate along the hair section by pressing and
holding the appropriate rotate button. Wind the entire section of hair
around the barrel until you reach the root. Release the rotate button
and then hold the brush in the hair for a few seconds.
• Repeat as necessary.
• After use, switch off and unplug the appliance.
• Allow to cool before storing away.
• Place protective shield over brush head to protect the bristles. Please
see the ‘Protective Cover’ section for direction
Heat Settings
There are 2 heats plus a cool setting. Slide the ‘on/off’ switch to the
rst position to select the cool setting ‘*’, the second position for the
low heat ‘I’, and the third position for the high heat ‘II’.
If you have delicate, ne or coloured hair, use the lower heat settings.
For thicker hair, use the higher heat settings.
Rotation Settings
To make the brush head rotate, press and hold the buttons marked
<< and >>, this will make the brush head rotate clockwise and anti-
clockwise.
Protective Cover
After every use, always ensure the protective cover is placed over the
brush head. This protects the bristles from damage. When placing
the protective cover over the brush head, ensure to line it up with the
grooves around the top of the airstyler so it slides easily into place.
NOTE: The diagram on the protective cover demonstrates the direction
it should be placed on to the brush head. If placed on incorrectly it
may be difcult to remove.

CLEANING & MAINTENANCE
To help keep your appliance in the best possible condition follow the
steps below:
• Ensure the appliance is switched off, unplugged and cool. To clean
the outside of the appliance, wipe with a damp cloth. Make sure that
no water enters the appliance and it is completely dry before use.
• Do not wrap the lead around the appliance, instead coil the lead
loosely by the side of the appliance.
• Do not use the appliance at a stretch from the power point.
• Always unplug after use.
Cleaning the Rear Filter
• Unplug the appliance and let it cool completely before cleaning it.
• Holding the handle of the appliance rmly, lift the lter open from the
grooves close to the cord bushing, this will enable the rear lter to
open.
• Using a soft brush, clean any hair and other debris from the lter.
• Replace the rear lter by closing the lter lid shut.
For more information on this appliance visit www.babyliss.co.uk

UK GUARANTEE
The Conair Group Ltd, Unit 3, Waterfront Business Park, Fleet,
GU51 3TW
This BaByliss appliance is guaranteed for consumer use for 2 years
and is only valid within the United Kingdom.
This guarantee covers consumer use only i.e. defects occurring under
normal use within the home from date of purchase or date of delivery,
whichever is later.
If the product develops a fault due to defects in materials or manufacture
within 12 months from the date of purchase, to avoid delays and
unnecessary inconvenience, where possible please return the product
to the point of purchase for an exchange.
If the product develops a fault due to defects in materials or manufacture
after 12 months from the date of purchase, and within the guarantee
period, Conair UK After Sales Service will repair or replace the product.
Exclusions
This guarantee will no longer be valid meaning that The Conair Group
Ltd will not be liable to repair or replace your product where:
1.) The appliance has been used on a voltage supply other than that
which is marked on the product, or advised within this instruction
booklet
2.) The appliance has been purchased from an unauthorised stockist*
3.) The appliance is used for professional / non domestic usage
4.) Repairs or alterations have been attempted by unauthorised persons
5.) The failure of the appliance is a direct result of misuse
6.) The failure is a result of not following the instructions for use
This guarantee does not cover any cosmetic damage due to misuse
of the product nor any damage to persons or property that occurs
because of product misuse.

*unauthorised stockists include, but are not limited to online auction
sites, private sellers and those selling second hand goods, refurbished
products etc
Please contact the Conair Customer Care Line on 03705 133 191
(09:00 to 17:00 Monday to Friday) or e-mail [e-mail] for
further information on authorised stockists.
It is important to retain your proof of purchase. We recommend
attaching your receipt to this page.
Even where a refund may be applicable, no refund will be provided
without a valid receipt or proof of purchase, we will only be able
to offer a repair or replacement service. Please note this does
not apply if the product was purchased directly from The Conair
Group Ltd.
Guarantees on replacement products run from the original purchase
date or date of delivery, whichever is later, and not from the date of
replacement.
This guarantee is an additional benefit and does not affect your
statutory rights as a consumer.
If you have any queries regarding this guarantee please contact the
Conair Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday
to Friday) or e-mail [e-mail]

UK AFTER SALES SERVICE
For further advice on using the appliance or should you need to return
your product, please contact the Conair Customer Care Line on
03705 133 191 (09:00 to 17:00 Monday to Friday) or e-mail your enquiry to
[e-mail]
Return address:
Customer Care Centre
Conair Logistics
Unit 4, Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your returns number, name and address details,
together with a copy of proof of purchase and details of the fault.
Please note this Instruction Booklet is not the guarantee.
SAFE DISPOSAL
The symbol on the product or on its packaging indicates that this
product may not be treated as household waste. Instead it should be
handed to an appropriate collection point for the recycling of Electrical
and Electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product. For more detailed
information about the recycling of this product, please contact your
local council ofce or your household waste disposal service.