BANKSTON Edition Office Lever 01 User manual

Install Instructions
Lever 01
Australia
14 - 16 Stepney Street,
Stepney, South Australia 5069
P: [phone]
[email protected]
bankstonarchitectural.com.au
New Zealand
P: [phone]
[email protected]
bankstonarchitectural.co.nz
SDG Trading Pty Ltd
trading as Bankston Architectural
ACN 008 154 041
ABN 18 008 154 041
Contact Us
Southern Design Group
*Image used for illustration
purposes only.
Scan for
Product &
Finish Care
Information
Scan for
New Zealand
Warranty
Scan for
Australian
Warranty

1.Marking the Door
1.1 Mark the edge of your door at the desired
height of your lever. See drill template
below.(Figure 1)
1.2 We recommend around 900mm–1000mm from
oor level, or at the centre of a lock rail
on a panel door.
1.3 Using a spirit level, mark the door at the
desired lever height, continuing the line from
the front of the door, around the edge and
onto the back of the door.(Figure 2)
1.4 We recommend extending the line 100mm
onto each face of the door.
2. Prepare Tie bolts
2.1 If using face x timber screws
(not recommended) proceed to step 3.2.
2.2 If required, shorten male tie bolt to suit
door thickness.
2.3 Ensure to cut so that the screw has enough
thread (12mm at least) to hold female thread.
(Figure 3)
3. Install Levers
3.1 Drill appropriate size holes and install
the halves on either side of the door,
ensuring the levers function in the correct
direction.(Figure 4)
3.2 Place the split spindles into the latch
from either side of the door.(Figure 5)
3.3 Fit the female tie bolts through
holes of one rose, then t male tie
bolts through the other side and tighten.
(Figure 5)
IMPORTANT:
Please install this hardware in the following
order to ensure its warranty is not voided.
1. Install the hardware on raw/unnished
door using the instructions provided.
2. Remove hardware (where possible) and
store safely. Do not place tape onto the
hardware as this will damage the nish.
3. Paint / nish door.
4. Reinstall hardware.
Figure 4
Figure 3
Figure 2
Figure 1
Preferred
product height
(1)
(4)
Figure 5
(4)
(1)
(1)
(4)
(3)
(3)
For number references please refer to included
items on reverse.

CUT ALONG DOTTED LINE
Included
Not Included
1. Passage Lever Set
2. Wood screws
3. Split Spindles 5. Spindle L100mm
6. Spindle L150mm
41.5
58
35 DIA
Backset
45/60/70mm
Door Edge
38
26
Lever 01
Drill Template
Scale 100%
Scale 30mm
Exploded Diagram
1.
3.
4.
4.
4. Tie Bolts