BANKSTON Edition Office Pull 03 Configuration guide

Install Instructions
Pull 03 W38 & W40
Australia
14 - 16 Stepney Street,
Stepney, South Australia 5069
P: [phone]
[email protected]
bankstonarchitectural.com.au
New Zealand
P: [phone]
[email protected]
bankstonarchitectural.co.nz
SDG Trading Pty Ltd
trading as Bankston Architectural
ACN 008 154 041
ABN 18 008 154 041
Contact Us
Southern Design Group
*Image used for illustration
purposes only.
Scan for
Product &
Finish Care
Information
Scan for
New Zealand
Warranty
Scan for
Australian
Warranty

1.Marking the Door
1.1. Mark the xing point on the edge of your door
at the desired height.(Figure 1)
1.2 Afx the template below on the door.(Figure 2)
1.3 Cut the cavity of the semi-circle using your
preferred method.(Figure 3)
1.4 Apply your preferred adhesive and t to cut out.
(Figure 3)
Figure 1
Figure 2 Figure 3
Not Included
Included
1. Cavity Pull
IMPORTANT:
Please install this hardware in the following order to ensure
its warranty is not voided.
1. Install the hardware on raw/unnished door using the
instructions provided.
2. Remove hardware (where possible) and store safely. Do
not place tape onto the hardware as this will damage the
nish.
3. Paint / nish door.
4. Reinstall hardware.

80
160 DIA
160
Door Edge
Pull 03
Cutting Template
100% Scale
Scale 30mm