BANKSTON Edition Office Pull 04 Configuration guide

Install Instructions
Pull 04 200mm
Australia
14 - 16 Stepney Street,
Stepney, South Australia 5069
P: [phone]
[email protected]
bankstonarchitectural.com.au
New Zealand
P: [phone]
[email protected]
bankstonarchitectural.co.nz
SDG Trading Pty Ltd
trading as Bankston Architectural
ACN 008 154 041
ABN 18 008 154 041
Contact Us
Southern Design Group
*Image used for illustration
purposes only.
Scan for
Product &
Finish Care
Information
Scan for
New Zealand
Warranty
Scan for
Australian
Warranty

1. Select the place of
installation. (Figure 1)
2.Afxthetemplatebelow
inside the drawer.(Figure 2)
3. Cut and remove the area
indicated using your preferred
method. If door / drawer
thickness is more than 17mm you
will need to recess the back
of the drawer so the front will
nishushwiththeface.
(Figure 3)
4. Drill appropriate sized
pilotholesandtscrews
from the inside of the drawer,
ensuring you do not drill
through the face of the drawer.
(Figure 4)
Included
1. Pull
2. Wood Screws
Not Included IMPORTANT:
Please install this hardware in the following order to ensure its
warranty is not voided.
1. Installthehardwareonraw/unnisheddoor/drawerusingthe
instructions provided.
2. Remove hardware (where possible) and store safely. Do not place
tapeontothehardwareasthiswilldamagethenish.
3. Paint/nishdoor.
4. Reinstall hardware.
Figure 2 Figure 3
Inside of drawer pictured
Figure 4
(1)
(2)
For number references please refer to
included items on reverse.
Figure 3 (recessed)
Inside of drawer pictured
(Drawer thickness great than 17mm)
Figure 1

40
200
50
7575
Pull 04 L200mm
Drilling Template
Scale 100%
Scale 30mm
Recess area
for drawer
thickness
greater
than 17mm

Dimensions
200
20
3
3
5
14
190
60
75 75
10
20
20
20
60
3
40
20
20
4 DIA