Bartec MC9000ex Series Use and care manual

Integration Manual
BARTEC
Sheett 1/7
MC9000ex – Series
Mobile Computer MC92NOex
RuBee

Integration Manual
BARTEC
Sheett 2/7
1. Table of contents
1. TABLE OF CONTENTS............................................................................................. 2
2. ASSEMBLY BOTTOM HOUSING ............................................................................. 3
2.1 RFID/RUBEE EXTERNAL BRICK.....................................................................................................3
2.2 RFID/RUBEE EXTERNAL GUN .......................................................................................................4
3. INSTALLATION RUBEE READER EXTERNAL (BRICK/GUN) ................................ 5

Integration Manual
BARTEC
Sheett 3/7
2. Assembly bottom housing
2.1 RFID/RuBee external Brick
1) Drill 7 holes (1,0mm) and 4 holes (5,5mm) with the
fixture in the lower housing.
Press 4 inserts into the big holes.
2) Lead the 7 wires (each with different colour) through the
drillings.
(LiY 0.08mm², d
iso
> 0.2mm)
3) Fill the RFID upper housing with Sikaflex as shown in
the picture.
4) Insert the pin with the hand strap into the recess.
Fix the pin with UV glue.
5) Fix the RFID lower housing with 4 screws and 4
washers with the top housing of the mobile computer.

Integration Manual
BARTEC
Sheett 4/7
6) Seal the screw heads and the wire openings with
Sikaflex.
7) Seal accomplished wires and inserts with Sikaflex.
2.2 RFID/RuBee external Gun
1) Drill 7 holes (1,0mm ) and 4 holes (5,5mm) with the
fixture in the lower housing.
Press 4 inserts into the big holes.
2) Lead the 7 wires (each with different colour) through the
drillings.
(LiY 0.08mm², d
iso
> 0.2mm)
3) Fill the RFID upper housing with Sikaflex as shown in
the picture.

Integration Manual
BARTEC
Sheett 5/7
4) Fix the RFID lower housing with 4 screws and 4
washers with the top housing of the mobile computer.
5) Seal the screw heads and the wire openings with
Sikaflex.
6) Seal accomplished wires and inserts with Sikaflex.
3. Installation RuBee Reader external (Brick/Gun)
1) Cut the antenna pins of the housing.
2) Insert RuBee Reader with Antenna into upper housing.
Solder the wires from antenna to reader.

Integration Manual
BARTEC
Sheett 6/7
3) Solder appropriate wires on RuBee Reader as shown in
the picture and fix them with UV glue.
4) Position the reader on the according 4 pins and glue
with UV glue.
5) Apply Sikaflex in the sealing area of the housing.
6) Put the RFID/RuBee lower housing on the upper
housing and press them together.
7) Fill the resin into the RFID/RuBee housing (without
empty space) and apply the opening of the lower
housing with Sikaflex.

Integration Manual
BARTEC
Sheett 7/7
8) Lock the opening with the according cover.