8 / 10 300055
Assembly
1. Under each shelf, check the marking for the bottom, centre or top shelves.
2. Start assembly with the bottom shelf (8, Fig. 2).
3. Place 4 spacers (6) in the corners of the bottom shelf.
NOTE!
Use a rubber mallet to hammer each spacer down until there are no gaps
between the spacers and the corner fixings of the bottom shelf.
4. First, place the back wall (4), inserting it into
the slots provided in the spacers (6).
5. In the same way, fit the side walls (5) on the
right and left sides into the spacers (6)
(Fig. 3).
6. Make sure that all the walls engage well in
the slots.
7. Next, place the centre shelf (7) over the spacers (6).
8. Place 4 further spacers (6) in the corners of the centre shelf (7). Use a rubber
mallet to fix the spacers correctly.
9. Repeat steps 4 and 5 to fix the back and side walls.
10.Before fitting the top shelf (2) to the serving trolley, fix both handles (1) onto it.
11.Secure the handles in the lower holes of the top shelf with the screws (3)
provided.
12.Now, using a rubber mallet, fix the top shelf (2) with the handles (1) fitted onto
the spacers (6).
13.If only one handle will be used instead of two, note the notch in the upper part —
see Fig. 1.
A–optional covers (10) for the serving trolley with one handle.
B–with handle screw when using covers.
