Bauhn HE414066 User manual

GETTING STARTED GUIDE
Model Number: HE414066
Cordless Headphones
1. Unpack
Unpack the contents of the Bauhn
Cordless Headphone pack.
2. Power the Base Unit
Insert the plug of the power adaptor to
the rear of the base unit. Plug in the
power adaptor to a power point and
turn on. The LED on the front of
the base unit will turn red when
connected to power.
Place the headphones on to the base
unit. The charge indicator will turn
yellow. Charge for 12 hours.
3. Turn on Cordless Headphones
When the base unit is powered, switch on the
headphones by pressing the power button on the
right ear piece.

Cordless Headphones
5. Select Channel
Select the channel you wish to use for your
Cordless Headphones. The switch used to toggle
between channels 1 to 3 is found on the rear of
the base unit.
Note: Change channels if you experience
interference or have multiple sets of headphones.
6. Scan for Channel
Press the Scan button on the side of the right ear
pad to scan for the channel you selected.
You may need to press scan a few times to tune
to the correct channel.
Congratulations, your Bauhn Cordless Headphones are ready to use.
4. Connect Audio to Base
Connect the base unit to your audio device
via either the RCA cables or 3.5mm audio cable.
The LED on the front of the base unit will turn green
when it detects audio input.
Tip: If the green LED does not light up, ensure
the volume on your device is set to maximum.