BDI Icon 9422 User manual

1
Step 2b
Install C-Frame
Attach C-frame oriented properly,
(Bottom of C-frame has 2 holes and
top of frame has 1 hole)
Designed by Cristian Wicha & Bill Becker.
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws. “Icon” and BDI are trademarks of
Becker Designed, Inc. All Rights reserved. ©2010, BDI
Made in Taiwan. 9422REV03112010v2
Your Icon®Home Theater Furniture is engineered for easy assembly.
Carefully follow this procedure to prevent any damage.
Placement and Maintenance
Icon®Home Theater Furniture is designed for indoor use on level floors.
Clean glass with glass cleaner, and steel parts and wood veneer with a
moist cloth.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some components
are shipped inside the cabinet. The assembly workspace should be a non-
marring surface such as carpet. For missing hardware pieces, please
contact BDI Customer Service at [email protected]. For all
other concerns, please contact your BDI Retailer.
Step 2a
Install Mouting Plate
Attach mounting plate to the upper and lower ends of C-frame.
Component List
C x 18
F x 4
E x 2
Dx 31
Gx 2
J x 1
C-Frame x 1
B x 12
A x 8
Ix 1
Glass Top x 1
Back Panel x 1
K x 7
Lx 7
Front Frame x 1
Mx 2
Shelf Brackets
x 12
Glass Shelves x 5
Base x 1
Ic o n ®
9422
a s s e m b l y instructions
b d i u s a .c o m customerservice@b d i u s a .c o m
Hx 1
J
J
E x 2
D x 4

2
assembly instructions
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Step 3
Install Frame onto Base
Use shown hardware to attach Base to Frame. Base is easiest to
install if unit is turned upside down. Install Levelers (F) to bottom of
Base. Adjust Levelers (F) so base is level and stable.
Step 4
Install Back Panel and Wire Managements Straps
Back Panel is to be installed with small holes
facing backward. BDI label should be on bottom
left corner of Back Panel.
Velcro straps are supplied to control cables.
They can be screwed into the small holes
on the Back Panel in location desired.
F x 8
A x 2
D x 3
H
L
G
K
J
J
I

3
assembly instructions
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Step 5
Install the Shelf Brackets
Shelf Brackets can be adjusted to offer two different shelf positions
for each shelf. Note: To reposition Shelf Brackets, it is not necessary
to remove the Back Panel.
Step 6
Install Glass Shelves
Use appropriate hardware. Apply Felt Washers to the stainless
pucks prior to glass installation.
PLEASE READ: Leave glass screws loose until all screws have been
installed. Then tighten securely. It may be nexessary to lossen Shelf
Brackets to obtain proper fit. Once Glass Shelves and Top Glass
are fitted, PLEASE BE CERTAIN TO GO BACK AND TIGHTEN ALL
SCREWS.
Top Glass
A x 3
C x 3
Shelf Glass
B x 3
C x 3
Bottom Shelf Glass
A x 3
C x 3
J
D
D
Shelf Brackets x 12