BeaconMedaes TotalAlert Infinity User manual

Quick Set-Up Guide: TotalAlert Infinity™Master Alarm
4107 9016 92.01
1
EnterBackspace
Close
Clear all
entered
text
Type the default password (121212) and touch
Enter. Choose continue or change password.
2
3
4
6
8
9
11
12
13
15
16
Select number of source locations for the above se-
lected gas (1 location per piece of source equipment)
To select alarm description text:
• Scroll through the options using the right and left
arrows at the bottom of the screen.
• Touch the tab for the appropriate option.
• Touch the Save button when you see a check beside
your selection to close and return to the SIGNAL
SETTINGS screen.
• Touch the X button in the upper right to save the
signal text and return to the CONFIGURE (SOURCE)
screen to set up remaining signals for the first
location.
• Set up remaining locations for the first gas (badge
1), then set up additional gases as needed following
steps 6-15.
• To return to the home screen, touch the heartbeat
icon.
7
Clear all
entered text
Cancel
After inputing source location, touch save, then select
the location to turn it green. Touch save.
14
10
Heartbeat
Icon Alarm Information History
Configuration
5
Save
Clear all
entered text
Cancel
Enter master alarm location and touch save.
Select appropriate gas and color code and touch save. Route each pair of signal input
wires as shown to appropriate
terminals on input board(s).
Touch the corresponding signal
point and touch save once the
point has been selected.
Note: Alarm may sound. Touch
the mute button to silence the
alarm.
Mute Button
Touch B to set the LOCATION text.
Touch 1 to set the gas and source locations, which will
be shown on badge 1.
Touch a blank location label to enter new text, or choose
an existing location label if the location has already been
set up. Touch save.
Touch the B1 tab to begin set up of the first alarm point
(B).

Wiring Diagram for NFPA TotalAlert Infinity™master alarm
WARNING:
RISK OF ELECTRIC SHOCK
Disconnect power at the circuit breaker before removing power supply shield.
1800 Overview Drive Rock Hill, SC 29730 (888) 4-MEDGAS [phone] Fax [phone] www.beaconmedaes.com
Quick Setup Guide: TotalAlert Infinity™ Master Alarm
Part number 4107 9016 92
Revision 01
April 27, 2015
This guide is intended for Quick Setup of the TotalAlert Infinity™master alarm.
For more detailed instructions, see the Operation and Maintenance Manual.