
bebob factory GmbH – Höglwörtherstr. 350 – D-81379 München – Tel.: +49 89 27818282
www.bebob.de
April 2020
Charging
•Never leave batteries unattended while charging
•Wait 30 Minutes after discharge before you put the battery on a charger.
•The bebob A200micro battery can be charged with an external bebob charger (or
equivalent) with Lithium-ion (Li-ion) charging ability.
•Approximate charge time may vary depending on charger and temperature.
•bebob A200micro can be charged in ambient temperature for optimum performance at
10°C - 30°C.
•bebob A200micro batteries can be recharged in any charge condition.
Discharging
•Maximum load is 16.0A. When using the battery with video or lighting equipment, power
consumption of the equipment must be 16.0A or below. For the protection of the battery, a
load of 16.0A or over may activate the internal protection circuit and stop supply of power.
In this case the status led will turn red.
•The battery can be used in ambient temperature of - 20°C - + 55°C.
Camera Data Communication
•Blue leds: Arri/Sony Data Protocol
•Red leds: Red Data Protocol
•To switch between both status, press the Check button for 5s
Status led
•Status led lighting Green: Full Capacity over 70% of New
•Status led lighting Yellow: Full Capacity between 50% and 70% of New
•Status led lighting Red: Full Capacity under 50% of New
Flash Light
•To switch On/Off press the Check Button Twice