Befaco ST AMP User manual

ST AMP
U S E R M A N U A L

S T A M P P O W E R & I N T R O
P O W E R I N G T H E
M O D U L E
U S E R M A N U A L
T H A N K S F O R P U R C H A S I N G A M O D U L E F R O M B E FA C O !
B E F O R E Y O U P L U G T H I S M O D U L E I N . . .
1. Disconnect your cabinet from the mains.
2. Triple check the power cord polarity. The coloured line on the cable
(pin number one) is the -12V rail.
3. If you plug the module backwards you might burn it out and
unfortunately this is not covered by the warranty.
4. If you have any questions about this product please send them to:
[e-mail]
I N T R O D U C T I O N S T A M P
ST Amp is a 1U stereo amplifier designed to boost your external signals into modular levels. The module is
designed under the Intellijel 1U format and uses the same pinout, making it fully compatible with the Intelljel
case's rear connectors.
M O D U L E
R E F E R E N C E PA N E L O V E R V I E W
1. Stereo Input
Module's audio input. This input is AC coupled to
improve audio performance.
2. Level Knob
Manual input attenuation
3. Gain Selector
Selects between x1, x5 or x10 amplification boost.
4. Stereo Outputs
Audio outputs with dedicated vu-meter LEDs.
.1

S T A M P F E A T U R E S
F E AT U R E S
U S E R M A N U A L
C O N N E C T I N G T H E U N I T T O A C A S E
ST Amp inputs can be linked to the rear Jack connectors found in cases like the Befaco 7U Case or
Intellijel 7U and Palette series. To do that, connect both ends of the provided 2x3 ribbon cable to
both the "INPUT" socket placed at the back of the module and the socket of your case (please refer
to the User Manual of your case to identify the socket linked to the rear jacks).
.2
M I S C E L A N E A S P E C S & C R E D I T S
* Size: 10HP
* Depth: 37mm
* +12v: 30mA
* -12v: 30mA
* Design: Pascual Rocher
ST AMP Input Pinout